4.6 Article

Spark Plasma Sintering of Graphene-Reinforced Inconel 738LC Alloy: Wear and Corrosion Performance

Journal

METALS AND MATERIALS INTERNATIONAL
Volume 28, Issue 3, Pages 695-709

Publisher

KOREAN INST METALS MATERIALS
DOI: 10.1007/s12540-020-00871-x

Keywords

Graphene nanoplatelets; Nickel-based composites; Mechanical properties; Corrosion; Wear properties

Funding

  1. Research and Innovation Directorate of the Tshwane University of Technology
  2. Department of Mechanical Engineering, Mechatronics and Industrial Design, Institute for Nano Engineering Research (INER) of the Tshwane University of Technology, Pretoria, South Africa
  3. Department of Chemical, Metallurgical and Materials Engineering of the Tshwane University of Technology, Pretoria, South Africa
  4. Faculty of Engineering and Built Environment of the Tshwane University of Technology, Pretoria, South Africa

Ask authors/readers for more resources

This study investigates the microstructure, corrosion, and tribological properties of spark plasma sintered graphene nanoplatelets (GNPs) reinforced Inconel 738 low carbon composites. The addition of GNPs greatly enhances the wear resistance and reduces the friction coefficient of the sintered composites.
This study aims to investigate the microstructure, corrosion and tribological properties of spark plasma sintered graphene nanoplatelets (GNPs) reinforced Inconel 738 low carbon composites. The matrix and reinforcement were thoroughly milled in order to ensure homogeneity. Thereafter, the milled powders were consolidated by using spark plasma sintering. The microstructural evolution and the phases formed were examined by the using scanning electron microscopy and X-ray diffractometry techniques. The corrosion analysis was investigated in acidic and basic media, while the tribological test was conducted under dry sliding conditions at varying loads. The results show that the microhardness values were significantly influenced by varying the GNPs constituents in Inconel 738LC from 384 to 459 HV0.5, while the sintered density was influenced by the sintering parameters. The corrosion response of the sintered composites in both acidic and basic media are comparable, irrespective of the varying GNPs content in the matrix. The wear performance suggests that the addition of GNPs to IN738LC, greatly enhanced the wear resistance and reduced the friction coefficient of the sintered IN738LC-GNPs composites. The improvement is attributed to the influence of the graphene-based tribofilm that formed on the sliding contact interface, which reduced friction coefficient. Likewise, graphene has a slight potential of forming continuous tribofilms at the friction interface due to its lubricity. It is thought that the GNPs reinforcement reduced the pull-out tendency, during wear activities.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available