4.7 Article

Water toxicity in reservoirs after freshwater algae harvest

Journal

JOURNAL OF CLEANER PRODUCTION
Volume 283, Issue -, Pages -

Publisher

ELSEVIER SCI LTD
DOI: 10.1016/j.jclepro.2020.124560

Keywords

Microalgae; Cyanobacteria; Microcystis sp; Microcystin; Harvesting

Funding

  1. Conselleira de Educacion, Universidade e Formacion Profesional, Xunta de Galicia, Espana [R815 131H 64502]

Ask authors/readers for more resources

Blooms of microalgae and cyanobacteria are increasing annually, posing significant environmental concerns. Harvesting these microalgae is crucial for water governance without releasing toxins. Among the three methods studied, electroflocculation showed the highest efficiency. However, post-harvesting toxicity levels may be affected by chlorophyll interference, requiring further research.
Blooms of microalgae and cyanobacteria increase every year, presenting great problems for the environment. Finding a way of harvesting these microalgae could be useful for water governance. Furthermore, the method should not cause cell lysis and should thus avoiding discharging toxins into the water. Three reservoirs were studied, two of them with eutrophication problems (As Conchas and A Baxe) and another (Salas) with no such problems. Three different harvesting methods were studied; electroflocculation (EF) with the application time being varied; centrifugation, with application times and speeds being varied; and finally, natural sedimentation. The highest efficiency was obtained in the culture from A Baxe, which had a higher initial absorbance value (1.664), using EF (90.64% for an application time of 2 min and 30 s) and centrifugation at 4000 rpm (92.25% fort minutes, 92.73% for 5 min). Electrofloculation can obtain up to 84% more biomass than natural sedimentation alone. Sample toxicity was studied before and after harvesting using Microcystest and found to be higher after harvesting. It was observed that for the same sample, the higher the yield was the greater the toxicity was. For the A Baxe culture with an application time of 2 min, a speed of 2000 rpm and a yield of 87.02%, a toxicity figure of 0.94 mu g/L was obtained, while for a speed of 4000 rpm the yield was 92.25% and the toxicity was 1.05 mu g/L. The toxicity limit set by the World Health Organization (WHO) is 1 mu g/L, and this small difference seems to be key. With these results, this study concludes that chlorophyll levels may interfere with the test used. Future tests or analyses should be developed so as to avoid such interference, which may alter the toxin values. Electroflocculation seems to be a promising method since it does not cause the lysis of Microcystis aeruginosa, whereas the centrifugation method could give problems. Finally, it is worth highlighting the importance of performing toxin measurements after harvesting the microalgae to check that the method is viable in natural ecosystems. (C) 2020 Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available