Related references
Note: Only part of the references are listed.Numerical simulation and application of oxygen lance in 120t BOF of PANSTEEL
Y. -H. Sun et al.
IRONMAKING & STEELMAKING (2017)
Behaviours of supersonic oxygen jet injected from four-hole lance during top-blown converter steelmaking process
H. Wang et al.
CANADIAN METALLURGICAL QUARTERLY (2014)
Simulation of three-phase flow and lance height effect on the cavity shape
Kai Dong et al.
INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2014)
Effect of operation parameters on supersonic jet behaviour of BOF six-nozzle oxygen lance
M. M. Li et al.
IRONMAKING & STEELMAKING (2014)
Potential CO2 emission reduction for BF-BOF steelmaking based on optimised use of ferrous burden materials
Chuan Wang et al.
INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2009)
Dynamic coupling of computational fluid dynamics and thermodynamics software: Applied on a top blown converter
Mikael Ersson et al.
ISIJ INTERNATIONAL (2008)
A mathematical model of an impinging air jet on a water surface
Mikael Ersson et al.
ISIJ INTERNATIONAL (2008)
A new lance design for BOF steelmaking
R. Sambasivam et al.
METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2007)
Fluid flow analysis of jets from nozzles in top blown process
Y Tago et al.
ISIJ INTERNATIONAL (2003)
Effect of nozzle twisted lance on jet behavior and spitting rate in top blown process
Y Higuchi et al.
ISIJ INTERNATIONAL (2003)
Splashing and spitting behaviour in the combined blown steelmaking converter
MJ Luomala et al.
ISIJ INTERNATIONAL (2002)
Effect of bottom nozzle arrangement on splashing and spitting in combined blowing converter
TMJ Fabritius et al.
ISIJ INTERNATIONAL (2002)
Effect of lance design on jet behavior and spitting rate in top blown process
Y Higuchi et al.
ISIJ INTERNATIONAL (2001)
Share Paper
