Journal
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
Volume 146, Issue 2, Pages 841-853Publisher
SPRINGER
DOI: 10.1007/s10973-020-10034-0
Keywords
Iron oxide nanoparticles; Nanofluid; Laminar flow; Heat exchanger
Ask authors/readers for more resources
Research shows that under a concentration of 0.1 vol%, the heat exchange performance of the car radiator is improved by approximately 21%, which is the optimal working condition, while increasing the nanoparticle concentration leads to heat transfer deterioration.
Increasing the heat transfer rate in car radiators by using nanofluids leads to better control of engine temperature at hard working conditions and reduces the required radiator dimensions. However, due to the possibility of disposal of radiator coolants in the environment, use of an eco-friendly nanofluid coolant is of particular importance. Therefore, in the current research, Fe3O4-water nanofluids with the nominal particle diameter of 28 nm were synthesized. The experiments were performed at vol% ranging from zero to 0.9, three radiator input temperatures (72, 80 and 88 degrees C) and four radiator fan speeds (1000, 1500, 2000 and 2500 rpm). Although the fluid flow rate was constant in this study, Re number varied in a narrow range (30-100) according to the change in the nanofluid concentration. It is interesting to say that the best working condition of the radiator obtained at 0.1 vol% and more increase in the nanoparticle concentration deteriorated the heat transfer. At 0.1 vol%, the heat exchanging performance of the radiator is improved by an average of 21% in comparison with the pure water. At this concentration, maximum Re number was also obtained according to the measured density and viscosity of the nanofluids. It can be concluded that at higher nanofluid concentrations (> 0.1 vol%), not only the particle agglomeration but also Re number reduction may lead to heat transfer deterioration. Moreover, at 0.1 vol% of nanoparticles, the outlet coolant temperature from the radiator decreased with increasing the radiator fan speed from 1000 to 2500 rpm. However, for temperatures more than 80 degrees C, the difference between the output fluid temperature at the fan speeds of 2000 and 2500 rpm was not significant. Therefore, as an overall conclusion, the concentration of 0.1 vol% and fan speed of 2000 rpm could be recommended in the car radiator with inlet temperatures at the range of 80-88 degrees C.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available