4.7 Article

Insights into endocrine-disrupting Bisphenol-A adsorption from pharmaceutical effluent by chitosan immobilized nanoscale zero-valent iron nanoparticles

Journal

JOURNAL OF MOLECULAR LIQUIDS
Volume 311, Issue -, Pages -

Publisher

ELSEVIER
DOI: 10.1016/j.molliq.2020.113317

Keywords

Endocrine-disrupting Bisphenol A; Chitosan; Nanoscale zero-valent iron; Adsorption; Differential evolution optimization; Response surface methodology

Funding

  1. Tehran University of Medical Sciences

Ask authors/readers for more resources

Bisphenol A (BPA) in the aquatic environment have adverse effects on human health and other living organisms. BPA at low traces can lead to cardiovascular disease, type II diabetes, and impaired hepatic enzymes. For efficient BPA removal, chitosan immobilized nanoscale zero-valent iron (nZVI-chitosan) nanoparticles were synthesized and used as adsorbent. Since the BPA removal efficiency depends on independent process variables like nZVI-chitosan dosage, initial BPA concentration, pH and contact time, experiments were conducted systematically. To characterize the interaction effect of these variables, the experimental matrix is designed using response surface methodology (RSM). The isothermal and kinetic model parameters are estimated using differential evolution optimization (DEO), and these parameters better represent adsorption behaviour. The batch adsorption experiments indicated that the BPA adsorption on to nZVI-chitosan follows pseudo 1st order kinetic models. The maximum extent of BPA adsorption was 65.16 mg/g based on the Langmuir isotherm model. DEO based model parameters better fit the non-linear models with high R-2 and lower RMSE. The regenerability experiments indicate that synthesized nZVI-chitosan adsorbent can be used up to three cycles with removal efficiency over 50%. The thermodynamic studies indicated that Delta G degrees is negative signifying a favourable and spontaneous adsorption process. The inhibition effects of coexisting ions on BPA adsorption followed the order of Mn2+ > Ca2+ > Mg2+ > Fe2+ for cations and of SO42- > NO3- > Cl- for anions. The BPA removal from real pharmaceutical waste water is 93.8% obtained for optimal initial BPA concentration of 6 mg/L, an adsorbent dosage of 1.5 g/L, with solution pH of 3 and adsorption time of 1 h, whereas this removal efficiency is 95% for synthetic wastewater. (C) 2020 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available