Journal
ADDITIVE MANUFACTURING
Volume 33, Issue -, Pages -Publisher
ELSEVIER
DOI: 10.1016/j.addma.2020.101039
Keywords
Additive manufacturing (AM); Powder bed fusion (PBF); Electron-beam melting (EBM); Titanium; Ti-6Al-4V; Hot isostatic pressing (HIP); Microstructure; Corrosion; Stress corrosion
Funding
- Kreitman School for Advanced Studies at the Ben-Gurion University of the Negev
- Israel Innovation Authority (IIA)
- AATiD
Ask authors/readers for more resources
Additive manufacturing (AM) is a rapidly growing technology that enables the fast production of complex and near-net-shaped (NNS) components. Among the many applicable AM methods (particularly powder bed technologies), electron-beam melting (EBM) is gaining increased interest mainly in aerospace and medical industries, due to its inherent advantages for the printing of Ti-6Al-4V alloy. Although major strides have been made towards understanding the effect of hot isostatic pressure (HIP) on the mechanical properties of Ti-6Al-4V produced by AM, its effect on corrosion performance remains relatively unexplored. To date, the reported corrosion studies remain essentially limited to the selective laser melting (SLM) process, while the corrosion behavior of EBM Ti-6Al-4V and particularly HIPed EBM Ti-6Al-4V have not been fully realized. This paper provides a detailed analysis of this corrosion performance, including the stress-corrosion susceptibility of EBM Ti-6Al-4V in as-build condition and after HIP heat treatment. Microstructure and phase identifications were examined by scanning electron microscopy (SEM) and X-ray diffraction analysis. Corrosion performance was evaluated by electrochemical measurements, including open-circuit potential (OCP), potentiodynamic polarization analysis and impedance spectroscopy (EIS), as well as stress-corrosion examination in terms of slow strain-rate testing (SSRT). All of the corrosion tests were carried out in a 3.5 wt% NaCl solution at ambient temperature. Owing to the natural excellent corrosion resistance of Ti-6Al-4V, the obtained results revealed that the HIP process has only a slight positive effect on the corrosion resistance of Ti-6Al-4V produced by EBM. This minor improvement may be related to the improved efficiency of the passivation layer that was attributed to the increased beta-phase content and the reduction of alpha/beta interfaces. In terms of stress corrosion sensitivity, the HIPed specimens exhibited extended time-to-failure (TTF) at the low strain rate at 2.5.10(-7) 1/sec, where the effect of the corrosive environment was more dominant.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available