Related references
Note: Only part of the references are listed.A Review on the Mechanical Modeling of Composite Manufacturing Processes
Ismet Baran et al.
ARCHIVES OF COMPUTATIONAL METHODS IN ENGINEERING (2017)
PvT-HADDOC: A multi-axial strain analyzer and cure monitoring device for thermoset composites characterization during manufacturing
Mael Peron et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2017)
Composite cure simulation scheme fully integrating internal strain measurement
Shu Minakuchi et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2016)
Predicting process-induced distortions in composite manufacturing - A pheno-numerical simulation strategy
Erik Kappel et al.
COMPOSITE STRUCTURES (2015)
Spring-back simulation of unidirectional carbon/epoxy flat laminate composite manufactured through autoclave process
L. Mezeix et al.
COMPOSITE STRUCTURES (2015)
Thermo-mechanical characterisation of in-plane properties for CSM E-glass epoxy polymer composite materials - Part 2: Young's modulus
J. Jakobsen et al.
POLYMER TESTING (2013)
Experimental identification of process parameters inducing warpage of autoclave-processed CFRP parts
D. Stefaniak et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2012)
Development of the properties of a carbon fibre reinforced thermosetting composite through cure
Nuri Ersoy et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2010)
Material characterization and residual stresses simulation during the manufacturing process of epoxy matrix composites
Y. Abou Msallem et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2010)
Measurement of (post-)curing strain development with fibre Bragg gratings
Patricia P. Parlevliet et al.
POLYMER TESTING (2010)
Assessment of cure residual strains through the thickness of carbon-epoxy laminates using FBGs, Part I: Elementary specimen
M. Mulle et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2009)
Deformation and stress build-up in bi-material beam specimens with a curing FM300 adhesive interlayer
Tomer Curiel et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2008)
In situ measurements of through-the-thickness strains during processing of AS4/8552 composite
Tomasz Garstka et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2007)
A note upon the development of residual curing strains in carbon/epoxy laminates. Study by thermomechanical analysis
PA Olivier
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2006)
Cure shrinkage measurement of nonconductive adhesives by means of a thermomechanical analyzer
H Yu et al.
JOURNAL OF ELECTRONIC MATERIALS (2005)
Thermomechanical properties during cure of glass-polyester RTM composites: Elastic and viscoelastic modeling
E Ruiz et al.
JOURNAL OF COMPOSITE MATERIALS (2005)
Numerical analysis of cure temperature and internal stresses in thin and thick RTM parts
E Ruiz et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2005)
Share Paper
