Journal
CERAMICS INTERNATIONAL
Volume 42, Issue 2, Pages 3338-3350Publisher
ELSEVIER SCI LTD
DOI: 10.1016/j.ceramint.2015.10.128
Keywords
Chromia; Zirconia toughened alumina; Machinability; Central composite design; Response surface methodology
Categories
Funding
- Science and Engineering Research Board (SERB) of Department of Science and Technology (DST), Govt of India, New Delhi [SB/S3/MMER/0035/2014]
Ask authors/readers for more resources
In present study, mechanical properties, microstructure and machining parameter optimization of Cr2O3 doped zirconia toughened alumina (ZTA) ceramic insert have been investigated for application in high speed turning of AISI 4340 steel with achieving maximum tool life. The yttria stabilized zirconia (YSZ) in alpha-Al2O3 matrix with varying percentage of co-doped chromia (Cr2O3) is prepared to study the phase transformation behaviour. The samples are uniaxially pressed in the form of cutting inserts and subsequently sintered at 1600 degrees C to evaluate the mechanical properties. Hardness and fracture toughness reaches the highest value i.e. 17.40 GPa and 7.20 MPa m(1/2) respectively at 0.6% Cr2O3 doped ZTA due to more metastable tetragonal ZrO2 phase present in the alumina matrix. After 50 min of machining, the flank wear and surface roughness are found well below the tool rejection criteria. The cutting force also does not affect detrimentally on the job tool interface. Turning experiments have been adopted as per central composite design (CCD) of response surface methodology (RSM) with varying 3 levels of cutting speed (140 m/min, 280 m/min, 420 m/min), feed rate (0.12 mm/rev, 0.18 mm/rev, 0.24 mm/rev) and depth of cut (0.50 mm, 1.00 mm, 1.50 mm). The effect of each input parameter on output responses is investigated using analysis of variance (ANOVA) and modelled using regression analysis. The influence of cutting speed, feed rate and depth of cut is observed maximum for determination of flank wear, cutting force and surface roughness respectively. Cutting speed of 420 m/min with feed rate of 0.12 mm/rev and depth of cut of 0.5 mm has been shown as optimized condition with 83.32% desirability for minimum tool failure and maximum tool life. (C) 2015 Elsevier Ltd and Techna Group S.r.l. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available