Related references
Note: Only part of the references are listed.Review of the Quench Sensitivity of Aluminium Alloys: Analysis of the Kinetics and Nature of Quench-Induced Precipitation
Benjamin Milkereit et al.
MATERIALS (2019)
Precipitation processes in Al-Mg-Si extending down to initial clustering revealed by the complementary techniques of positron lifetime spectroscopy and dilatometry
L. Resch et al.
JOURNAL OF MATERIALS SCIENCE (2018)
Influence of Solution-Annealing Parameters on the Continuous Cooling Precipitation of Aluminum Alloy 6082
Hannes Froeck et al.
METALS (2018)
Quantitative volumetric identification of precipitates in dilute alloys using high-precision isothermal dilatometry
E. Hengge et al.
PHILOSOPHICAL MAGAZINE LETTERS (2018)
Effect of quench-induced precipitation on microstructure and mechanical properties of 7085 aluminum alloy
Shengdan Liu et al.
MATERIALS & DESIGN (2017)
In Situ Real-Time Monitoring of Aging Processes in an Aluminum Alloy by High-Precision Dilatometry
Martin Luckabauer et al.
MAGNESIUM TECHNOLOGY 2017 (2017)
Continuous cooling precipitation diagram of aluminium alloy AA7150 based on a new fast scanning calorimetry and interrupted quenching method
Bin Yang et al.
MATERIALS CHARACTERIZATION (2016)
Precipitation of a new platelet phase during the quenching of an Al-Zn-Mg-Cu alloy
Yong Zhang et al.
SCIENTIFIC REPORTS (2016)
The effect of anodising on the fatigue performance of self-tapping aluminium screws
D. Groeber et al.
INTERNATIONAL JOURNAL OF FATIGUE (2015)
Dissolution and Precipitation Behaviour during Continuous Heating of Al-Mg-Si Alloys in a Wide Range of Heating Rates
Julia Osten et al.
MATERIALS (2015)
Predicting the quench sensitivity of Al-Zn-Mg-Cu alloys: A model for linear cooling and strengthening
Marco J. Starink et al.
MATERIALS & DESIGN (2015)
Early precipitation during cooling of an Al-Zn-Mg-Cu alloy revealed by in situ small angle X-ray scattering
P. Schloth et al.
APPLIED PHYSICS LETTERS (2014)
The effect of material properties and joining process parameters on behavior of self-pierce riveting joints made with the solid rivet
Jacek Mucha
MATERIALS & DESIGN (2013)
Precipitation enthalpy during cooling of aluminum alloys obtained from calorimetric reheating experiments
Davit Zohrabyan et al.
THERMOCHIMICA ACTA (2012)
Quenching Simulation of Aluminum Alloys Including Mechanical Properties of the Undercooled States
Michael Reich et al.
MATERIALS PERFORMANCE AND CHARACTERIZATION (2012)
Fast scanning power compensated differential scanning nano-calorimeter: 1. The device
E. Zhuravlev et al.
THERMOCHIMICA ACTA (2010)
The continuous cooling precipitation diagram of an aluminum alloy EN AW-6005A
B. Milkereit et al.
HTM-JOURNAL OF HEAT TREATMENT AND MATERIALS (2010)
Influence of cooling rate on the precipitation microstructure in a medium strength Al-Zn-Mg alloy
A. Deschamps et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)
Recording of continuous cooling precipitation diagrams of aluminium alloys
Benjamin Milkereit et al.
THERMOCHIMICA ACTA (2009)
Share Paper
