Related references
Note: Only part of the references are listed.Application of a hybrid nanofluid containing graphene nanoplatelet-platinum composite powder in a triple-tube heat exchanger equipped with inserted ribs
Mehdi Bahiraei et al.
APPLIED THERMAL ENGINEERING (2019)
Comparative performance assessment of solar dish assisted s-CO2 Brayton cycle using nanofluids
Muhammad Sajid Khan et al.
APPLIED THERMAL ENGINEERING (2019)
Two-phase forced convection of nanofluids flow in circular tubes using convergent and divergent conical rings inserts
Hussein A. Mohammed et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2019)
A comparative study on the thermal performance of water in a circular tube with twisted tapes, perforated twisted tapes and perforated twisted tapes with alternate axis
Sneha Ponnada et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2019)
Research and development on composite nanofluids as next-generation heat transfer medium
Vivek Kumar et al.
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2019)
Numerical and experimental investigations on heat transfer and pressure drop characteristics of Al2O3-TiO2 hybrid nanofluid in minichannel heat sink with different mixture ratio
Vivek Kumar et al.
POWDER TECHNOLOGY (2019)
Heat transfer performance of TiO2-SiO2 nanofluids in a tube with wire coil inserts
K. Abdul Hamid et al.
APPLIED THERMAL ENGINEERING (2019)
Heat transfer and pressure drop characteristics of alternating clockwise and counter clockwise twisted tape inserts in the transitional flow regime
S. M. Abolarin et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)
Recent advances in application of nanofluids in heat transfer devices: A critical review
Muhammad Usman Sajid et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2019)
Development of new correlations for heat transfer and friction loss of solid ring with combined square wing twisted tape inserts heat exchanger tube
Ravi Datt et al.
EXPERIMENTAL HEAT TRANSFER (2019)
Potential of gear-ring turbulator in three-dimensional heat exchanger tube from second law of thermodynamic viewpoint
Navid Moghaddaszadeh et al.
INTERNATIONAL JOURNAL OF NUMERICAL METHODS FOR HEAT & FLUID FLOW (2019)
Impact of variable fluid properties on forced convection of Fe3O4/CNT/water hybrid nanofluid in a double-pipe mini-channel heat exchanger
Amin Shahsavar et al.
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2019)
Recent advances in modeling and simulation of nanofluid flows-Part II: Applications
Omid Mahian et al.
PHYSICS REPORTS-REVIEW SECTION OF PHYSICS LETTERS (2019)
Recent advances in modeling and simulation of nanofluid flows-Part I: Fundamentals and theory
Omid Mahian et al.
PHYSICS REPORTS-REVIEW SECTION OF PHYSICS LETTERS (2019)
Factorial experimental design for the thermal performance of a double pipe heat exchanger using Al2O3 -TiO2 hybrid nanofluid
Heydar Maddah et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2018)
Thermal conductivity of hybrid nanofluids: A critical review
Muhammad Usman Sajid et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
Improving the performance of refrigeration systems by using nanofluids: A comprehensive review
Atul Bhattad et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2018)
PERFORMANCE STUDY OF CONICAL STRIP INSERTS IN TUBE HEAT EXCHANGER USING WATER BASED TITANIUM OXIDE NANOFLUID
Mahalingam Arulprakasajothi et al.
THERMAL SCIENCE (2018)
Preparation Techniques of TiO2 Nanofluids and Challenges: A Review
Hafiz Muhammad Ali et al.
APPLIED SCIENCES-BASEL (2018)
Double-sided delta-wing tape inserts to enhance convective heat transfer and fluid flow characteristics of a double-pipe heat exchanger
Agung Tri Wijayanta et al.
APPLIED THERMAL ENGINEERING (2018)
Cu-water nanofluid flow and heat transfer in a heat exchanger tube equipped with cross-cut twisted tape
M. E. Nakhchi et al.
POWDER TECHNOLOGY (2018)
Heat transfer enhancement of internal flow by inserting punched delta winglet vortex generators with various attack angles
Agung Tri Wijayanta et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2017)
Heat transfer, friction factor and effectiveness of Fe3O4 nanofluid flow in an inner tube of double pipe U-bend heat exchanger with and without longitudinal strip inserts
N. T. Ravi Kumar et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2017)
Improving the thermal hydraulic performance of a circular tube by using punched delta-winglet vortex generators
Yonggang Lei et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)
Graphene nanoplatelets nanofluids thermal and hydrodynamic performance on integral fin heat sink
Waqas Arshad et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)
Experimental investigation of heat transfer and pressure drop in a straight minichannel heat sink using TiO2 nanofluid
Waqas Arshad et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)
Thermo-hydraulic analysis for a novel eccentric helical screw tape insert in a three dimensional tube
Navid Moghadas Zade et al.
APPLIED THERMAL ENGINEERING (2017)
Thermo-fluid performance and entropy generation analysis for a new eccentric helical screw tape insert in a 3D tube
S. Rashidi et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2017)
Tapered Twisted Tape Inserts for Enhanced Heat Transfer
B. V. N. Ramakumar et al.
JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2016)
Experimental investigation of nanofluid free convection over the vertical and horizontal flat plates with uniform heat flux by PIV
R. Parizad Laein et al.
ADVANCED POWDER TECHNOLOGY (2016)
Experimental investigation of heat transfer augmentation inside double pipe heat exchanger equipped with reduced width twisted tapes inserts using polymeric nanofluid
Mohammad Hazbehian et al.
HEAT AND MASS TRANSFER (2016)
Opposition of Magnetohydrodynamic and AL2O3-water nanofluid flow around a vertex facing triangular obstacle
S. Rashidi et al.
JOURNAL OF MOLECULAR LIQUIDS (2016)
Recovery of drop in heat transfer rate for a rotating system by nanofluids
Saeedreza Zeibi Shirejini et al.
JOURNAL OF MOLECULAR LIQUIDS (2016)
Graphene nanoplatelets-silver hybrid nanofluids for enhanced heat transfer
Hooman Yarmand et al.
ENERGY CONVERSION AND MANAGEMENT (2015)
A review on hybrid nanofluids: Recent research, development and applications
Jahar Sarkar et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2015)
Experimental investigation on convective heat transfer and rheological characteristics of Cu-TiO2 hybrid nanofluids
D. Madhesh et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2014)
Comparative study on thermal performance of twisted tape and wire coil inserts in turbulent flow using CuO/water nanofluid
M. T. Naik et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2014)
Experimental investigation of heat transfer coefficient and friction factor of ethylene glycol water based TiO2 nanofluid in double pipe heat exchanger with and without helical coil inserts
M. Chandra Sekhara Reddy et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2014)
Enhanced heat transfer and friction factor of MWCNT-Fe3O4/water hybrid nanofluids
L. Syam Sundar et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2014)
Experimental study of Al2O3/water nanofluid turbulent heat transfer enhancement in the horizontal double pipes fitted with modified twisted tapes
Heydar Maddah et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2014)
Study on heat transfer and friction factor characteristics of γ-Al2O3/water through circular tube with twisted tape inserts with different thicknesses
E. Esmaeilzadeh et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2014)
Effect of conical cut-out turbulators with internal fins in a circular tube on heat transfer and friction factor
C. Muthusamy et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2013)
Heat transfer enhancement of nanofluids in a double pipe heat exchanger with louvered strip inserts
H. A. Mohammed et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2013)
Heat transfer and exergy loss in conical spring turbulators
Hakan Karakaya et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2013)
HEAT TRANSFER ENHANCEMENT IN THE SHELL SIDE OF THE SELF-SUPPORT IN RECTANGULAR CONVERGING-DIVERGING TUBE BUNDLE HEAT EXCHANGERS WITH DIFFERENT INSERTS
Feng Jiao et al.
HEAT TRANSFER RESEARCH (2012)
Effect of full length twisted tape inserts on heat transfer and friction factor enhancement with Fe3O4 magnetic nanofluid inside a plain tube: An experimental study
L. Syam Sundar et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2012)
Thermal Performance Assessment of Turbulent Tube Flow Through Wire Coil Turbulators
Smith Eiamsa-Ard et al.
HEAT TRANSFER ENGINEERING (2011)
On the Use of Wire-Coil Inserts to Augment Tube Heat Transfer
Neal R. Herring et al.
JOURNAL OF ENHANCED HEAT TRANSFER (2009)
Application of hybrid sphere/carbon nanotube particles in nanofluids
Z. H. Han et al.
NANOTECHNOLOGY (2007)
Share Paper
