Related references
Note: Only part of the references are listed.Evaluation of Bonding Quality in the Carbon Fiber--Reinforced Polymer (CFRP) Composite Laminates by Measurements of Local Vibration Nonlinearity
Igor Solodov et al.
RESEARCH IN NONDESTRUCTIVE EVALUATION (2019)
Improving nondestructive characterization of dual phase steels using data fusion
Saeed Kahrobaee et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2018)
Study of Formation and Reversion of the Martensitic Phase Induced by Deformation of Lean Duplex Stainless Steel
C. S. P. Mendonca et al.
JOURNAL OF NONDESTRUCTIVE EVALUATION (2018)
Characterization of reverse martensitic transformation in cold-rolled austenitic 316 stainless steel
Javier Fava et al.
Materia-Rio de Janeiro (2018)
Examination of Barkhausen noise parameters for characterisation of strain-induced martensitic transformation in AISI 304 stainless steel
E Ahmadzade-Beiraki et al.
INSIGHT (2016)
Microstructural Characterization of Quenched AISI D2 Tool Steel Using Magnetic/Electromagnetic Nondestructive Techniques
Saeed Kahrobaee et al.
IEEE TRANSACTIONS ON MAGNETICS (2015)
Correlation between martensitic phase transformation and magnetic Barkhausen noise of AISI 304 steel
Miriam Rocio Neyra Astudillo et al.
INTERNATIONAL CONGRESS OF SCIENCE AND TECHNOLOGY OF METALLURGY AND MATERIALS, SAM - CONAMET 2014 (2015)
Characterization of strain-induced martensitic transformation in A301 stainless steel by Barkhausen noise measurement
P. Hausild et al.
MATERIALS & DESIGN (2013)
Eddy current nondestructive evaluation of dual phase steel
Sadegh Ghanei et al.
MATERIALS & DESIGN (2013)
Eddy Current Assessment of the Cold Rolled Deformation Behavior of AISI 321 Stainless Steel
Kunpeng Liu et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2012)
High temperature resistant eddy current sensor for in situ monitoring the material microstructure development of steel alloys during heat treatment - bainite sensor
H. Kluemper-Westkamp et al.
EUROSENSORS XXV (2011)
Characterization of strain-induced martensitic transformation in a metastable austenitic stainless steel
P. Hausild et al.
MATERIALS & DESIGN (2010)
Monitoring of Martensitic Transformation in Austenitic Stainless Steel 304L by Eddy Currents
Maher Shaira et al.
RESEARCH IN NONDESTRUCTIVE EVALUATION (2010)
Eddy current detection of changes in stainless steel after cold reduction
S. H. Khan et al.
COMPUTATIONAL MATERIALS SCIENCE (2008)
Non-destructive indication of plastic deformation of cold-rolled stainless steel by magnetic adaptive testing
G. Vertesy et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2007)
Compositional dependence of magnetic properties on thermally sensitized austenitic stainless steels
Y. Kamada et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2007)
Eddy currents and hardness testing for evaluation of steel decarburizing
D. Mercier et al.
NDT & E INTERNATIONAL (2006)
Magnetic Barkhausen noise from strain-induced martensite during low cycle fatigue of 304L austenitic stainless steel
A Vincent et al.
ACTA MATERIALIA (2005)
Magnetic investigation of the effect of α′-martensite on the properties of austenitic stainless steel
I Mészáros et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2005)
Strengthening via the formation of strain-induced martensite in stainless steels
K Spencer et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)
The characterisation of work-hardened austenitic stainless steel by NDT micro-magnetic techniques
D O'Sullivan et al.
NDT & E INTERNATIONAL (2004)
Influence of phase transformations on the mechanical properties of austenitic stainless steels
AA Lebedev et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2000)
Share Paper
