Anode structure with double-catalyst layers for improving the direct ethanol fuel cell performance

The conventional anode design of direct ethanol fuel cells (DEFCs) usually encounter a problem on the performance stability and ethanol mass transport, i.e., ethanol crossover. Aiming to alleviate these issues, in this study, the anode with different configurations for DEFC was designed and fabricated with different catalyst layer (CL) and microporous layer (MPL) arrangements. The four types of membrane electrode assembly (MEA) is named with MEA-1 (with pretreated carbon paper (PCP) and PtCL), MEA-2 (with PCP, MPL and PtCL), MEA-3 (with PCP, MPL, PtCL and PdCL) and MEA-4 (with PCP, MPL, PtCL, MPL and PdCL). The performance, stability and ethanol crossover of MEAs were tested and measured for continuous long-term operation for 120 h, while the morphological characterization was analyzed. Based on the results, power density for each MEA decreased with time, while ethanol crossover increased gradually. The MEA-3 with additional PdCL shows a highest performance and stability about 20 W/m(2), and has a lowest ethanol crossover's magnitude. The highest ethanol crossover was obtained using MEA-1 at 3.7 mg/m(2).s. Higher ethanol crossover had caused low stability of DEFC performance which result higher irreversible degradation. Moreover, based on characterization, elemental mapping and EDX illustrated phenomena of membrane swelling, delamination of electrode from membrane, and CL loss after stability test for 5 days for all MEAs. The significance of anode structure design was proven in this current study. The anode design of double-layered CL has potential to use at anode structure to reduce ethanol crossover rate, thereby improving DEFC performance and stability. (C) 2019 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.