4.7 Article

Control of NOx and other emissions in micro gas turbine combustors fuelled with mixtures of methane and ammonia

Journal

COMBUSTION AND FLAME
Volume 211, Issue -, Pages 406-416

Publisher

ELSEVIER SCIENCE INC
DOI: 10.1016/j.combustflame.2019.10.012

Keywords

Micro gas turbine; Ammonia; Fuel NOx; Rich-lean combustion; Emissions control

Funding

  1. Council for Science, Technology and Innovation (CSTI)
  2. Cross-ministerial Strategic Innovation Promotion Program (SIP), Energy Carriers (Funding Agency: The Japan Science and Technology Agency (JST))
  3. Institute of Fluid Science, Tohoku University

Ask authors/readers for more resources

Methane-ammonia mixtures have potentials as low-carbon fuels for gas turbines, however significantly high fuel NOx production in their flames present challenges to their application. This study aims to provide deep insight into the physical and chemical processes involved in the formation and control of emissions from the combustion of CH4-NH3-air with up to 30% ammonia by heat fraction in gas turbine combustors. Hence, laser diagnostics techniques such as Particle Image Velocimetry (PIV), and Planar Laser Induced Fluorescence (PLIF) imaging, in addition to Fourier Transform Infrared (FTIR) gas analysis were employed to study the flow field, flame structure and emissions characteristics of a micro gas turbine swirl combustor fuelled with CH4-NH3-air mixtures. The control of emissions from the flames was further studied using Large Eddy Simulation (LES) of a model swirl combustor. The results show that NOx emissions from premixed CH4-NH3-air in single-stage combustion were more than 5000 ppmv at equivalence ratios, Phi = 0.8-1.1, which is about twice more than the values already reported for NH3-air. Trends in NOx emissions correspond with the trends in OH radicals concentration in the combustor owing to the relevance of OH radicals in fuel NOx production. Emissions control leading to significantly low emissions such as 49 ppmv of NOx, 2 ppmv of CO and approximately zero N2O, HCN and NH3 emissions with a 99.8% combustion efficiency was achieved using rich-lean combustion. An optimum Phi of the primary combustion zone for low NOx emission was identified, which varied from 1.30 to 1.35 depending on the ammonia fraction. For Phi richer (leaner) than the optimum Phi, NOx emission increased due to an increase in NOx production in the secondary (primary) combustion zone. Rich-lean combustion of CH4-NH3-air emitted less NOx than that of NH3-air because the higher flame speed of CH4-NH3-air mixtures ensured lower NOx production in the secondary combustion zone. (C) 2019 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available