4.7 Article

Emission characteristics of turbulent non-premixed ammonia/air and methane/air swirl flames through a rich-lean combustor under various wall thermal boundary conditions at high pressure

Journal

COMBUSTION AND FLAME
Volume 210, Issue -, Pages 247-261

Publisher

ELSEVIER SCIENCE INC
DOI: 10.1016/j.combustflame.2019.08.037

Keywords

Ammonia; Methane; Gas turbine; Emission; Rich-lean combustion; Wall thermal boundary

Funding

  1. Council for Science, Technology and Innovation (CSTI), the Cross-ministerial Strategic Innovation Promotion Program (SIP), Energy Carriers (Japan Science and Technology Agency (JST))
  2. Institute of Fluid Science, Tohoku University

Ask authors/readers for more resources

This study is dedicated to understanding the combustion and emission characteristics of turbulent non-premixed ammonia (NH3)/air and methane (CH4)/air swirl flames in a rich-lean gas turbine-like combustor at high pressure under various wall thermal boundary conditions. In this study, the emission characteristics of both flames were obtained through numerical simulations using large-eddy simulations with the finite-rate chemistry technique. In addition, for NH3/air flames, simultaneous NO and OH planar laser-induced fluorescence (PLIF) images were acquired in order to qualitatively verify the numerical results. The results show that the minimum NO emission could be obtained when the primary zone global equivalence ratio (phi(global/pri)) was 1.1, irrespective of the wall thermal condition, using a rich-lean cornbustor in NH3/air flames, whereas in CH4/air flames, the maximum NO emission was obtained with a phi(global/pri) value of 1.0. Moreover, in NH3/air flames, the local NO concentration is largely dependent on the local OH concentration, whereas in CH4/air flames, the local NO concentration is largely dependent on the local temperature. The NO-OH correlation in NH3/air flames was experimentally verified using simultaneous NO and OH PLIF images. Additionally, it was found that, in NH3/air flames, the wall heat losses due to the combustor wall cooling greatly affected the NH3 oxidation and led to significant emissions of unburnt NH3, although lower NO emission resulted from the combustor wall cooling. This was primarily because of the lower OH concentration level in the flame region owing to the wall heat losses. (C) 2019 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available