Related references
Note: Only part of the references are listed.Notch bluntness effects on fracture toughness of a modified S690 steel at 150 °C
J. -S. Kim et al.
ENGINEERING FRACTURE MECHANICS (2018)
Size and geometry effects in notched compact tension specimens
A. J. Horn et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2017)
Blunt defect assessment in the framework of the failure assessment diagram
Jae-Jun Han et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2016)
Estimation of elastic-plastic fracture toughness by numerical simulation based on a stress-based criterion for ductile crack initiation
Masayuki Kamaya
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2014)
A stress-based criterion for ductile crack initiation of pre-strained carbon steel
Masayuki Kamaya
ENGINEERING FRACTURE MECHANICS (2012)
An engineering assessment methodology for non-sharp defects in steel structures - Part I: Procedure development
A. J. Horn et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2012)
An engineering assessment methodology for non-sharp defects in steel structures - Part II: Procedure validation and constraint analysis
A. J. Horn et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2012)
A finite element ductile failure simulation method using stress-modified fracture strain model
Chang-Sik Oh et al.
ENGINEERING FRACTURE MECHANICS (2011)
Comparison of fracture strain based ductile failure simulation with experimental results
Nak-Hyun Kim et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2011)
Structural integrity assessment of components subjected to low constraint conditions
Sergio Cicero et al.
ENGINEERING FRACTURE MECHANICS (2008)
The fracture mechanics of finite crack extension
D Taylor et al.
ENGINEERING FRACTURE MECHANICS (2005)
Calculation of the energy J-integral for bodies with notches and cracks
YG Matvienko et al.
INTERNATIONAL JOURNAL OF FRACTURE (2004)
Investigation of blunting line and evaluation of fracture toughness under mixed mode I/III loading in commercially pure titanium
SV Kamat et al.
MATERIALS SCIENCE AND TECHNOLOGY (2003)
Share Paper
