4.7 Article

Assessment of factors influencing PM mass concentration measured by gravimetric & beta attenuation techniques at a suburban site

Journal

ATMOSPHERIC ENVIRONMENT
Volume 131, Issue -, Pages 409-417

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.atmosenv.2016.02.010

Keywords

PM2.5, PM10; Beta-attenuation monitor; Reference gravimetric sampler; Water content; Filter material; Equivalence

Funding

  1. EnTeC FP7 Capacities programme (REGPOT, FP7) [316173]
  2. Hellenic State of Scholarship Foundation (IKY)

Ask authors/readers for more resources

Near real-time atmospheric particulate matter (PM) monitors are extensively used in air quality networks given their ability to provide continuous measurements with minimal attention by the operator. Their principle of operation is based on measurement of a physical parameter that is quantitatively linked to the PM mass concentration. Significant discrepancies between these measurements and those obtained by the reference gravimetric method, conducted in regions with diverse climatic conditions, have been reported in the literature. In this study we compare systematic PM2.5 and PM10 gravimetric (GM) and beta attenuation (BA) measurements performed at a suburban site in Athens, Greece, over a period of 4 years (2009-2012). In general, BA and GM datasets exhibited similar temporal variation for both PM size fractions. An overestimation of the BA measurements, which was similar to 30% for the PM2.5 and similar to 10% for the PM10 data, was observed. Good linear correlations between GM and BA data were observed, with estimated Pearson coefficients being 0.79 for the PM2.5 and 0.85 for the PM10 measurements. The respective fitted equations through the entire dataset were BA = 0.71 GM + 6.2, and BA = 0.77 G M + 4.1. Better correlation between GM and BA measurements was observed during the cold rather than the Warm period. Discrepancies between BA and GM PM2.5 measurements increased with increasing available water vapor, suggesting that the aerosol bound water has a strong effect on the measurements. The effect of filter material used for GM measurements (i.e., quartz, glass fiber, or Teflon) was also examined for the PM2.5 dataset. Best correlation between BA and GM data was observed when glass fiber, which is incidentally the material of the BA filter tape, was used in the GM measurements. When the BA to GM relationship was examined by further categorizing the data by the season (i.e., cold and warm period) for different filter types, the relationships that were fitted to the data for the two seasons were similar when Teflon filters were used, but quite diverse when quartz and glass fiber filters were employed in the GM measurements. Finally, the variability of the ratio between the two measurement techniques was found to be potentially dependent on the availability of the volatility or stability in the aerosol phase of species such as ammonium nitrate. (C) 2016 Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available