Related references
Note: Only part of the references are listed.Effects of 3D Printing Project-based Learning on Preservice Elementary Teachers' Science Attitudes, Science Content Knowledge, and Anxiety About Teaching Science
Elena Novak et al.
JOURNAL OF SCIENCE EDUCATION AND TECHNOLOGY (2018)
Industrial and Consumer Uses of Additive Manufacturing A Discussion of Capabilities, Trajectories, and Challenges
Haden Edward Quinlan et al.
JOURNAL OF INDUSTRIAL ECOLOGY (2017)
Perspective on 3D printing of separation membranes and comparison to related unconventional fabrication techniques
Ze-Xian Low et al.
JOURNAL OF MEMBRANE SCIENCE (2017)
Dimensional and form errors of PC parts printed via Fused Deposition Modelling
A. Reyes-Rodriguez et al.
MANUFACTURING ENGINEERING SOCIETY INTERNATIONAL CONFERENCE 2017 (MESIC 2017) (2017)
Optimization of fused deposition modeling process parameters for dimensional accuracy using I-optimality criterion
Omar Ahmed Mohamed et al.
MEASUREMENT (2016)
Mechanical properties of parts fabricated with inkjet 3D printing through efficient experimental design
J. Mueller et al.
MATERIALS & DESIGN (2015)
An Additive Manufacturing Test Artifact
Shawn Moylan et al.
JOURNAL OF RESEARCH OF THE NATIONAL INSTITUTE OF STANDARDS AND TECHNOLOGY (2014)
Determination of optimum SLA process parameters of H-shaped parts
Emad Rajabi Khorasani et al.
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2013)
Evaluation of post-curing and laser manufacturing parameters on the properties of SOMOS 7110 photosensitive resin used in stereolithography
G. V. Salmoria et al.
MATERIALS & DESIGN (2009)
Statistical analysis of the stereolithographic process to improve the accuracy
S. L. Campanelli et al.
COMPUTER-AIDED DESIGN (2007)
Using response surface methodology to optimize the stereolithography process
Gamal Weheba et al.
RAPID PROTOTYPING JOURNAL (2006)
Parametric process optimization to improve the accuracy of rapid prototyped stereolithography parts
JG Zhou et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2000)