4.7 Article

Experimental and kinetic study on laminar burning velocities of 1,3-butadiene at pressures up to 1.5 MPa

Journal

FUEL
Volume 246, Issue -, Pages 222-231

Publisher

ELSEVIER SCI LTD
DOI: 10.1016/j.fuel.2019.02.133

Keywords

Laminar burning velocity; 1,3-Butadiene; Elevated pressure; Sensitivity analysis; Pathway analysis

Funding

  1. National Natural Science Foundation of China [91641124, 91441203]
  2. Project of Youth Star in Science and Technology of Shaanxi Province [2018KJXX-031]
  3. Fundamental Research Funds for the Central Universities
  4. State Key Laboratory of Engines at Tianjin University [K2018-10]

Ask authors/readers for more resources

1,3-butadiene(C4H6) is important for the oxidation and pyrolysis of long-chain hydrocarbons and the formation of soot. In this study, the laminar burning velocities of 1,3-butadiene/O-2/He mixtures were measured using the spherically propagating flame at initial temperature of 298 K, initial pressure of 0.5-1.5 MPa and equivalence ratio of 0.8-1.5. The laminar burning velocities of 1,3-butadiene/air mixtures were also measured at initial temperature of 298-398 K, initial pressure of 0.1-0.5 MPa and equivalence ratio of 0.7-1.6. Comparison was made between experimental and calculated results of USC MECH II and AramcoMech 3.0. Both mechanisms show good prediction on laminar burning velocities of 1,3-butadiene/air mixtures, but only AramcoMech 3.0 mechanism gives good prediction on the measured laminar burning velocity of 1,3-butadiene/O-2/He mixtures at higher pressures. Sensitivity analysis was made to analyze the effects of temperature, pressure and equivalence ratio on reaction pathways. Difference between two mechanisms was observed in the sensitivity of C4H6+ O reactions, and pathway analysis was performed to further study the reaction pathways. Consumption pathways are almost the same for 1,3-butadiene/air and 1,3-butadiene/O-2/He mixtures. The two mechanisms have consistent opinions of C4H6+ H reactions, but totally different opinions on the pathway of C4H6+ O reactions. It can be found that more C3H6 is present in USC MECH II, leading to the laminar burning velocity with USC MECH II are lower than that of AramcoMech 3.0.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available