Related references
Note: Only part of the references are listed.Mechanical behavior of non-silicate based alkali-activated ground granulated blast furnace slag
Virendra Kumar et al.
CONSTRUCTION AND BUILDING MATERIALS (2019)
Novel synergy of Si-rich minerals and reactive MgO for stabilisation/solidification of contaminated sediment
Lei Wang et al.
JOURNAL OF HAZARDOUS MATERIALS (2019)
Effect of sewage sludge ash on mechanical and microstructural properties of geopolymers based on metakaolin
D. B. Istuque et al.
CONSTRUCTION AND BUILDING MATERIALS (2019)
Green remediation of As and Pb contaminated soil using cement-free clay-based stabilization/solidification
Lei Wang et al.
ENVIRONMENT INTERNATIONAL (2019)
Rapid evaluation of leaching potential of heavy metals from municipal solid waste incineration fly ash
Yang Yue et al.
JOURNAL OF ENVIRONMENTAL MANAGEMENT (2019)
Alkaline fused phosphate mine tailings for geopolymer mortar synthesis: Thermal stability, mechanical and microstructural properties
S. Moukannaa et al.
JOURNAL OF NON-CRYSTALLINE SOLIDS (2019)
Sustainable stabilization/solidification of municipal solid waste incinerator fly ash by incorporation of green materials
Liang Chen et al.
JOURNAL OF CLEANER PRODUCTION (2019)
Low-carbon and low-alkalinity stabilization/solidification of high-Pb contaminated soil
Lei Wang et al.
CHEMICAL ENGINEERING JOURNAL (2018)
Improving strength of calcinated coal gangue geopolymer mortars via increasing calcium content
Guodong Huang et al.
CONSTRUCTION AND BUILDING MATERIALS (2018)
Solidification/stabilization mechanism of Pb(II), Cd(II), Mn(II) and Cr(III) in fly ash based geopolymers
Yaguang Wang et al.
CONSTRUCTION AND BUILDING MATERIALS (2018)
Strength evaluation by using polycarboxylate superplasticizer and solidification efficiency of Cr6+, Pb2+ and Cd2+ in composite based geopolymer
Faheem Muhammad et al.
JOURNAL OF CLEANER PRODUCTION (2018)
Mechanical and microstructural characterization of geopolymers derived from red mud and fly ashes
Wei Hu et al.
JOURNAL OF CLEANER PRODUCTION (2018)
Characterization of naturally aged cement-solidified MSWI fly ash
Bing Du et al.
WASTE MANAGEMENT (2018)
Co-disposal of MSWI fly ash and electrolytic manganese residue based on geopolymeric system
Xinyuan Zhan et al.
WASTE MANAGEMENT (2018)
Efficiency and mechanism of stabilization/solidification of Pb(II), Cd(II), Cu(II), Th(IV) and U(VI) in metakaolin based geopolymers
Bassam I. Ei-Eswed et al.
APPLIED CLAY SCIENCE (2017)
Combustion properties of coal gangue using thermogravimetry-Fourier transform infrared spectroscopy
Jun Deng et al.
APPLIED THERMAL ENGINEERING (2017)
Solidification/stabilization of chromite ore processing residue using alkali-activated composite cementitious materials
Xiao Huang et al.
CHEMOSPHERE (2017)
Mechanochemical and thermal activation of kaolin for manufacturing geopolymer mortars - Comparative study
Ida Balczar et al.
CERAMICS INTERNATIONAL (2016)
Immobilization of chromite ore processing residue with alkali-activated blast furnace slag-based geopolymer
Xiao Huang et al.
CERAMICS INTERNATIONAL (2016)
Impact of activator type on the immobilisation of lead in fly ash-based geopolymer
Sujeong Lee et al.
JOURNAL OF HAZARDOUS MATERIALS (2016)
Geopolymers with a high percentage of bottom ash for solidification/immobilization of different toxic metals
Rozineide A. Antunes Boca Santa et al.
JOURNAL OF HAZARDOUS MATERIALS (2016)
Co-disposal of MSWI fly ash and Bayer red mud using an one-part geopolymeric system
Nan Ye et al.
JOURNAL OF HAZARDOUS MATERIALS (2016)
Characteristics of municipal solid waste incineration fly ash with cement solidification treatment
Rushan Bie et al.
JOURNAL OF THE ENERGY INSTITUTE (2016)
Effect of synthesis parameters on the quality of construction and demolition wastes (CDW) geopolymers
Kostas Komnitsas et al.
ADVANCED POWDER TECHNOLOGY (2015)
Effects of the experimental factors on the microstructure and the properties of cured alkali-activated heated clay
K. El Hafid et al.
APPLIED CLAY SCIENCE (2015)
Effect of cure temperature on the formation of metakaolinite-based geopolymer
F. G. M. Aredes et al.
CERAMICS INTERNATIONAL (2015)
How does Na, K alkali metal concentration change the early age structural characteristic of kaolin-based geopolymers
Ayi D. Hounsi et al.
CERAMICS INTERNATIONAL (2014)
Effect of temperature and alkaline concentration on metakaolin leaching kinetics
N. Granizo et al.
CERAMICS INTERNATIONAL (2014)
The influence of the NaOH solution on the properties of the fly ash-based geopolymer mortar cured at different temperatures
Gokhan Gorhan et al.
COMPOSITES PART B-ENGINEERING (2014)
Effects SiO2/Na2O molar ratio on mechanical properties and the microstructure of nano-SiO2 metakaolin-based geopolymers
Kang Gao et al.
CONSTRUCTION AND BUILDING MATERIALS (2014)
Effect of blast furnace slag grades on fly ash based geopolymer waste forms
Hui Xu et al.
FUEL (2014)
Characterization of alkali activated kaolinitic clay
Faten Slaty et al.
APPLIED CLAY SCIENCE (2013)
Geopolymers: a new and smart way for a sustainable development Preface
P. Benito et al.
APPLIED CLAY SCIENCE (2013)
Quantitative Analysis of Sodium Carbonate and Sodium Bicarbonate in Solid Mixtures Using Fourier Transform Infrared Spectroscopy (FT-IR)
Shailesh Joshi et al.
APPLIED SPECTROSCOPY (2013)
Micromechanical characterization of metakaolin-based geopolymers
F. Pelisser et al.
CONSTRUCTION AND BUILDING MATERIALS (2013)
Strength of geopolymer cured in saline water in ambient conditions
Haider M. Giasuddin et al.
FUEL (2013)
Micro-structural characterization of the hydration products of bauxite-calcination-method red mud-coal gangue based cementitious materials
Xiaoming Liu et al.
JOURNAL OF HAZARDOUS MATERIALS (2013)
Alkaline Activation of Ceramic Waste Materials
L. Reig et al.
WASTE AND BIOMASS VALORIZATION (2013)
Effects of Water Content and Chemical Composition on Structural Properties of Alkaline Activated Metakaolin-Based Geopolymers
Maricela Lizcano et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2012)
Toxicity mitigation and solidification of municipal solid waste incinerator fly ash using alkaline activated coal ash
E. Ivan Diaz-Loya et al.
WASTE MANAGEMENT (2012)
The effects of Na2O/SiO2 molar ratio, curing temperature and age on compressive strength, morphology and microstructure of alkali-activated fly ash-based geopolymers
Alexandre Silva de Vargas et al.
CEMENT & CONCRETE COMPOSITES (2011)
Advances in alternative cementitious binders
M. C. G. Juenger et al.
CEMENT AND CONCRETE RESEARCH (2011)
The origin of the pozzolanic activity of calcined clay minerals: A comparison between kaolinite, illite and montmorillonite
Rodrigo Fernandez et al.
CEMENT AND CONCRETE RESEARCH (2011)
Pozzolanic behaviour of compound-activated red mud-coal gangue mixture
Na Zhang et al.
CEMENT AND CONCRETE RESEARCH (2011)
Immobilization of MSWI fly ash through geopolymerization: Effects of water-wash
Lei Zheng et al.
WASTE MANAGEMENT (2011)
Effect of curing temperature on the development of hard structure of metakaolin-based geopolymer
Pavel Rovnanik
CONSTRUCTION AND BUILDING MATERIALS (2010)
Investigation on the activation of coal gangue by a new compound method
Chao Li et al.
JOURNAL OF HAZARDOUS MATERIALS (2010)
Influence of degree of dehydroxylation on the pozzolanic activity of metakaolin
Ch. Bich et al.
APPLIED CLAY SCIENCE (2009)
Role of water in the synthesis of calcined kaolin-based geopolymer
Z. Zuhua et al.
APPLIED CLAY SCIENCE (2009)
Characteristics of municipal solid wastes incineration (MSWI) fly ash-cement matrices and effect of mineral admixtures on composite system
Hui-sheng Shi et al.
CONSTRUCTION AND BUILDING MATERIALS (2009)
Effects of Municipal Solid Waste Incinerator Fly Ash Slag on the Strength and Porosity of Slag-Blended Cement Pastes
Kae-Long Lin et al.
ENVIRONMENTAL ENGINEERING SCIENCE (2009)
Waste stabilization/solidification of an electric arc furnace dust using fly ash-based geopolymers
C. Fernandez Pereira et al.
FUEL (2009)
Influence of calcium compounds on the mechanical properties of fly ash geopolymer pastes
J. Temuujin et al.
JOURNAL OF HAZARDOUS MATERIALS (2009)
Water retention properties of porous geopolymers for use in cooling applications
Kiyoshi Okada et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2009)
Geopolymers for immobilization of Cr6+, Cd2+, and Pb2+
Jianguo Zhang et al.
JOURNAL OF HAZARDOUS MATERIALS (2008)
Alteration of kaolinite to cancrinite and sodalite by simulated hanford tank waste and its impact on cesium retention
HT Zhao et al.
CLAYS AND CLAY MINERALS (2004)
Fire-resistant geopolymer produced by granulated blast furnace slag
TW Cheng et al.
MINERALS ENGINEERING (2003)