Related references
Note: Only part of the references are listed.A damage mechanical model applied to analysis of mechanical properties of jointed rock masses
Wendong Yang et al.
TUNNELLING AND UNDERGROUND SPACE TECHNOLOGY (2019)
Distinguishing fractures from matrix pores based on the practical application of rock physics inversion and NMR data: A case study from an unconventional coal reservoir in China
Naser Golsanami et al.
JOURNAL OF NATURAL GAS SCIENCE AND ENGINEERING (2019)
Fracture failure analysis of hard and thick key layer and its dynamic response characteristics
Lishuai Jiang et al.
ENGINEERING FAILURE ANALYSIS (2019)
Numerical Analysis of Support Designs Based on a Case Study of a Longwall Entry
Lishuai Jiang et al.
ROCK MECHANICS AND ROCK ENGINEERING (2019)
Influence of Different Advancing Directions on Mining Effect Caused by a Fault
Lishuai Jiang et al.
ADVANCES IN CIVIL ENGINEERING (2019)
The effect of anionic surfactant (SDS) on pore-fracture evolution of acidified coal and its significance for coalbed methane extraction
Ni Guanhua et al.
ADVANCED POWDER TECHNOLOGY (2019)
Development of cement dust suppression technology during shotcrete in mine of China-A review
Lianjun Chen et al.
JOURNAL OF LOSS PREVENTION IN THE PROCESS INDUSTRIES (2018)
Evaluation method of rockburst: State-of-the-art literature review
Jian Zhou et al.
TUNNELLING AND UNDERGROUND SPACE TECHNOLOGY (2018)
Physical simulation of mining effect caused by a fault tectonic
Pu Wang et al.
ARABIAN JOURNAL OF GEOSCIENCES (2018)
A numerical study of fracture spacing and through-going fracture formation in layered rocks
Liwei Guo et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2017)
Numerical Approach for Goaf-Side Entry Layout and Yield Pillar Design in Fractured Ground Conditions
Lishuai Jiang et al.
ROCK MECHANICS AND ROCK ENGINEERING (2017)
Assessment of the Energy Balance of Rock Masses through Discrete Element Modelling
Jabrane Hamdi et al.
ISRM EUROPEAN ROCK MECHANICS SYMPOSIUM EUROCK 2017 (2017)
Practical Investigations on Use of Weighted Joint Density to Decrease the Limitations of RQD Measurements
Mohammad Haftani et al.
ROCK MECHANICS AND ROCK ENGINEERING (2016)
Influence of fracture-induced weakening on coal mine gateroad stability
Lishuai Jiang et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2016)
3D numerical analysis of crack propagation of heterogeneous notched rock under uniaxial tension
S. Y. Wang et al.
TECTONOPHYSICS (2016)
Development and applications of rock fracture mechanics modelling with FRACOD: a general review
Baotang Shen
GEOSYSTEM ENGINEERING (2014)
Experimental and numerical analysis of indirect and direct tensile strength using fracture mechanics concepts
A. Fahimifar et al.
BULLETIN OF ENGINEERING GEOLOGY AND THE ENVIRONMENT (2012)
Stability investigations around a mine tunnel through three-dimensional discontinuum and continuum stress analyses
Xin Wang et al.
TUNNELLING AND UNDERGROUND SPACE TECHNOLOGY (2012)
Influence of Loading Rate on Deformability and Compressive Strength of Three Thai Sandstones
Kittitep Fuenkajorn et al.
GEOTECHNICAL AND GEOLOGICAL ENGINEERING (2010)
New method for determining the elastic parameters of rock mass layers in the region of underground mining influence
Krzysztof Tajdus
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2009)
An interacting micro-crack damage model for failure of brittle materials under compression
B. Paliwal et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2008)
A numerical study of the influence of heterogeneity on the strength characterization of rock under uniaxial tension
C. A. Tang et al.
MECHANICS OF MATERIALS (2007)
Quantification of rock mass damage in underground excavations from microseismic event monitoring
M Cai et al.
INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2001)