Related references
Note: Only part of the references are listed.Strain rate dependence on the evolution of microstructure and deformation mechanism during nanoscale deformation in low carbon-high Mn TWIP steel
K. Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Mechanism of huge Luders-type deformation in ultrafine grained austenitic stainless steel
Si Gao et al.
SCRIPTA MATERIALIA (2019)
High temperature deformation behavior of carbon-containing FeCoCrNiMn high entropy alloy
Jianbo Li et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2018)
Strain rate effects of dynamic compressive deformation on mechanical properties and microstructure of CoCrFeMnNi high-entropy alloy
Jeong Min Park et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Edge-Cracking Behavior of CoCrFeMnNi High-Entropy Alloy During Hot Rolling
Jong Woo Won et al.
METALS AND MATERIALS INTERNATIONAL (2018)
Modeling Deformation Flow Curves and Dynamic Recrystallization of BA-160 Steel During Hot Compression
Babak Shahriari et al.
METALS AND MATERIALS INTERNATIONAL (2018)
Post Deformation at Room and Cryogenic Temperature Cooling Media on Severely Deformed 1050-Aluminum
M. Sarkari Khorrami et al.
METALS AND MATERIALS INTERNATIONAL (2018)
Evolutions of diffusion activation energy and Zener-Hollomon parameter of ultra-high strength Al-Zn-Mg-Cu-Zr alloy during hot compression
Yuanwei Sun et al.
PROGRESS IN NATURAL SCIENCE-MATERIALS INTERNATIONAL (2018)
Deformation behavior of ultra-fine-grained Mg-0.3 at% Al alloy in compression
Viera Gartnerova et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2017)
Design of new face-centered cubic high entropy alloys by thermodynamic calculation
Won-Mi Choi et al.
METALS AND MATERIALS INTERNATIONAL (2017)
In situ click chemistry generation of cyclooxygenase-2 inhibitors
Atul Bhardwaj et al.
NATURE COMMUNICATIONS (2017)
Enhanced strength and ductility of bulk CoCrFeMnNi high entropy alloy having fully recrystallized ultrafine-grained structure
S. J. Sun et al.
MATERIALS & DESIGN (2017)
Ror2 signaling regulates Golgi structure and transport through IFT20 for tumor invasiveness
Michiru Nishita et al.
SCIENTIFIC REPORTS (2017)
A critical review of high entropy alloys and related concepts
D. B. Miracle et al.
ACTA MATERIALIA (2017)
Ab initio assisted design of quinary dual-phase high-entropy alloys with transformation-induced plasticity
Zhiming Li et al.
ACTA MATERIALIA (2017)
A TRIP-assisted dual-phase high-entropy alloy: Grain size and phase fraction effects on deformation behavior
Zhiming Li et al.
ACTA MATERIALIA (2017)
A precipitation-hardened high-entropy alloy with outstanding tensile properties
J. Y. He et al.
ACTA MATERIALIA (2016)
Metastable high-entropy dual-phase alloys overcome the strength-ductility trade-off
Zhiming Li et al.
NATURE (2016)
Dynamic tension-compression asymmetry of martensitic transformation in austenitic Fe-(0.4,1.0)C-18Mn steels for cryogenic applications
Hyunmin Kim et al.
ACTA MATERIALIA (2015)
Design of a twinning-induced plasticity high entropy alloy
Y. Deng et al.
ACTA MATERIALIA (2015)
The influence of stacking fault energy on the microstructural and strainhardening evolution of Fe-Mn-Al-Si steels during tensile deformation
D. T. Pierce et al.
ACTA MATERIALIA (2015)
Effect of cryo-deformation on structure and properties of CoCrFeNiMn high-entropy alloy
N. Stepanov et al.
INTERMETALLICS (2015)
Effect of V content on microstructure and mechanical properties of the CoCrFeMnNiVx high entropy alloys
N. D. Stepanov et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2015)
Nano-twin mediated plasticity in carbon-containing FeNiCoCrMn high entropy alloys
Z. Wu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2015)
Non-equiatomic high entropy alloys: Approach towards rapid alloy screening and property-oriented design
K. G. Pradeep et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Temperature dependent stacking fault energy of FeCrCoNiMn high entropy alloy
Shuo Huang et al.
SCRIPTA MATERIALIA (2015)
Martensite Formation in Conventional and Isothermal Tension of 304 Austenitic Stainless Steel Measured by X-ray Diffraction
Newell H. Moser et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2014)
Mechanisms of toughness improvement in Charpy impact and fracture toughness tests of non-heat-treating cold-drawn steel bar
Hyunmin Kim et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Quasi-static and dynamic compressive deformation behaviors in Zr-based amorphous alloys containing ductile dendrites
Changwoo Jeon et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Hot deformation behavior of Ti-15-3 titanium alloy: a study using processing maps, activation energy map, and Zener-Hollomon parameter map
Jingqi Zhang et al.
JOURNAL OF MATERIALS SCIENCE (2012)
Thermodynamic modeling of the stacking fault energy of austenitic steels
S. Curtze et al.
ACTA MATERIALIA (2011)
Dependence of tensile deformation behavior of TWIP steels on stacking fault energy, temperature and strain rate
S. Curtze et al.
ACTA MATERIALIA (2010)
Microstructural evolution and low temperature impact toughness of a Fe-13%Cr-4%Ni-Mo martensitic stainless steel
Y. Y. Song et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
Stacking fault energy and plastic deformation of fully austenitic high manganese steels: Effect of Al addition
Kyung-Tae Park et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
Stability of austenite and quasi-adiabatic heating during high-strain-rate deformation of twinning-induced plasticity steels
Puspendu Sahu et al.
SCRIPTA MATERIALIA (2010)
A low-temperature study to examine the role of ε-martensite during strain-induced transformations in metastable austenitic stainless steels
K. Datta et al.
ACTA MATERIALIA (2009)
Is there a relationship between the stacking fault character and the activated mode of plasticity of Fe-Mn-based austenitic steels?
H. Idrissi et al.
SCRIPTA MATERIALIA (2009)
An alternative model for the strain hardening of FCC alloys that twin, validated for twinning-induced plasticity steel
Javier Gil Sevillano
SCRIPTA MATERIALIA (2009)
Inverse temperature dependence of toughness in an ultrafine grain-structure steel
Yuuji Kimura et al.
SCIENCE (2008)
Tensile properties and twinning behavior of high manganese austenitic steel with fine-grained structure
R. Ueji et al.
SCRIPTA MATERIALIA (2008)
Effect of grain and twin boundaries on the hardening mechanisms of twinning-induced plasticity steels
O. Bouaziz et al.
SCRIPTA MATERIALIA (2008)
Deformation-induced phase transformation and strain hardening in type 304 austenitic stainless steel
Amar K. De et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2006)
Cold rolling behaviour of an austenitic, Fe-30Mn-3Al-3Si TWIP-steel: the importance of deformation twinning
S Vercammen et al.
ACTA MATERIALIA (2004)
Temperature dependence of strain hardening and plastic instability behaviors in austenitic stainless steels
TS Byun et al.
ACTA MATERIALIA (2004)
Nanostructured high-entropy alloys with multiple principal elements: Novel alloy design concepts and outcomes
JW Yeh et al.
ADVANCED ENGINEERING MATERIALS (2004)
Impact properties and microstructure evolution of 304L stainless steel
WS Lee et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2001)