Effect of Mo and Cr additions on the microstructure, mechanical properties and pitting corrosion resistance of austenitic Fe-30Mn-10.5Al-1.1C lightweight steels

Five Fe-30 wt%Mn-10.5 wt%Al-1.1 wt%C steels containing different Mo and Cr contents were prepared to investigate the effect of Mo and Cr addition on the microstructure, mechanical properties and pitting corrosion resistance of austenitic lightweight steels. The microstructures of all samples after solution treatment at 1050 degrees C consisted of austenite and kappa-carbide, while DO3 ordered phases were additionally formed in samples containing 3 wt%Mo-3wt%Cr or 5 wt%Cr. The results of Nanoindentation tests indicated that the intrinsic strength of the austenite matrix decreased with the addition of Mo and Cr due to the suppression of kappa-carbide precipitation and then the strength of the DO3 phase is equal or higher as compared to the austenite matrix. The tensile tests also showed that the yield strength decreased when 3 wt%Mo or 3 wt%Cr was added due to the suppression of kappa-carbide precipitation, whereas it increased with further additions of Mo and Cr in both cases due to the formation of a DO3 ordered phases and grain refinement. Electrochemical tests showed that the resistance to pitting corrosion was improved by the addition of Mo and Cr due to the formation of a protective passive film; however, the excessive additions of Mo or Cr adversely deteriorated the resistance to pitting corrosion as the DO3 ordered phase which acted as pit initiation sites. (C) 2018 Elsevier B.V. All rights reserved.