Effects of flash boiling injection on in-cylinder spray, mixing and combustion of a spark-ignition direct-injection engine

Higher engine efficiency and ever stringent pollutant emission regulations are considered as the most important challenges for today's automotive industry. Fast evaporation and combustion technique has caused unprecedented attention due to its potential to solve both of the above challenges. Flash boiling, which features a two-phase flow that constantly generates vapor bubbles inside the liquid spray is ideal to achieve fast evaporation and combustion inside direct-injection (DI) gasoline engines. In this study, three spray conditions, including liquid, transitional flash boiling and flare flash boiling spray were studied for comparison under cold start condition in a spark-ignition direct-injection (SIDI) optical gasoline engine. Optical access into the combustion chamber includes a quartz linear and a quartz insert on the piston. In separate experiments, we recorded the crank angle resolved spray morphology using laser scattering technique, and distribution of fuel before ignition employing laser induced fluorescence technology, as well as time-resolved color images of flame with high-speed camera. The spray morphology during the intake stroke shows stronger plume-plume and plume-air interaction under flash boiling condition, as well as smaller penetration. Then around the end of compression (before ignition), the fuel distribution is also shown to be more homogeneous with less cyclic variation under flash boiling. Finally, from the color images of the flame, it was found that with the increase of superheat degree, the diffusion rate of blue flame (generated by excited molecules) is higher, which is considered to be related with the larger fractal dimension of the flame front. Also, the combustion is more complete with less yellow flame under flash boiling. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.