4.6 Article

Determination of Nonconductive Coating Thickness Using Electrical Contact Conductance and Surface Profile

Journal

COATINGS
Volume 8, Issue 9, Pages -

Publisher

MDPI
DOI: 10.3390/coatings8090310

Keywords

coating; film thickness; roughness; surface analysis; tribology

Funding

  1. 2017 Korea Aerospace University Faculty Research Grant

Ask authors/readers for more resources

This paper describes a method to determine the thickness of a nonconductive coating by identifying the transition of material by a change in electrical properties. A slide-hold-slide test was conducted with a worn specimen including an electrodeposited coating layer. Relative displacement was imposed between a metallic stylus tip and a worn steel specimen. After an initial sliding, the tip was held for a certain time to measure electrical contact resistance. During the test, the vertical displacement of the stylus tip was also recorded to draw a surface profile of the worn specimen. Coating thickness on the specimen was determined with a surface profile at the transition of electrical contact conductance. Optical cross-section measurement of the specimen was applied to identify actual coating thickness. Measured results reveal that calculated coating thicknesses are in good agreement with measured values by an optical microscope. The proposed method allows determination of both nonconductive coating thickness and surface profile in a single measurement.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available