4.7 Article

Three-dimensional dynamic models of subducting plate-overriding plate-upper mantle interaction

Journal

JOURNAL OF GEOPHYSICAL RESEARCH-SOLID EARTH
Volume 118, Issue 2, Pages 775-790

Publisher

AMER GEOPHYSICAL UNION
DOI: 10.1002/jgrb.50078

Keywords

-

Funding

  1. Australian Research Council [DP110103387, DP120102983, FT110100560]
  2. Australian Research Council [FT110100560] Funding Source: Australian Research Council

Ask authors/readers for more resources

We present fully dynamic generic three-dimensional laboratory models of progressive subduction with an overriding plate and a weak subduction zone interface. Overriding plate thickness (T-OP) is varied systematically (in the range 0-2.5 cm scaling to 0-125 km) to investigate its effect on subduction kinematics and overriding plate deformation. The general pattern of subduction is the same for all models with slab draping on the 670 km discontinuity, comparable slab dip angles, trench retreat, trenchward subducting platemotion, and a concave trench curvature. The narrow slab models only show overriding plate extension. Subduction partitioning (nu(SP perpendicular to)/(nu(SP perpendicular to)+nu(T perpendicular to))) increases with increasing T-OP, where trenchward subducting plate motion (nu(SP perpendicular to)) increases at the expense of trench retreat (nu(T perpendicular to)). This results from an increase in trench suction force with increasing T-OP, which retards trench retreat. An increase in T-OP also corresponds to a decrease in overriding plate extension and curvature because a thicker overriding plate provides more resistance to deform. Overriding plate extension is maximum at a scaled distance of similar to 200-400 km from the trench, not at the trench, suggesting that basal shear tractions resulting from mantle flow below the overriding plate primarily drive extension rather than deviatoric tensional normal stresses at the subduction zone interface. The force that drives overriding plate extension is 5%-11% of the slab negative buoyancy force. The models show a positive correlation between nu(T perpendicular to) and overriding plate extension rate, in agreement with observations. The results suggest that slab rollback and associated toroidal mantle flow drive overriding plate extension and backarc basin formation. Citation: Meyer, C., and W. P. Schellart (2013), Three-dimensional dynamic models of subducting plate-overriding plate-upper mantle interaction, J. Geophys. Res. Solid Earth, 118, 775-790, doi:10.1002/jgrb.50078.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available