Related references
Note: Only part of the references are listed.Improved atomic force microscopy cantilever performance by partial reflective coating
Zeno Schumacher et al.
BEILSTEIN JOURNAL OF NANOTECHNOLOGY (2015)
Reconstruction of surface potential from Kelvin probe force microscopy images
G. Cohen et al.
NANOTECHNOLOGY (2013)
Decoupling conservative and dissipative forces in frequency modulation atomic force microscopy
Aleksander Labuda et al.
PHYSICAL REVIEW B (2011)
Note: Quantitative (artifact-free) surface potential measurements using Kelvin force microscopy
T. Melin et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2011)
Energy levels of few-electron quantum dots imaged and characterized by atomic force microscopy
Lynda Cockins et al.
PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA (2010)
Dynamic behavior of amplitude detection Kelvin force microscopy in ultrahigh vacuum
H. Diesinger et al.
ULTRAMICROSCOPY (2010)
Open source scanning probe microscopy control software package GXSM
Percy Zahl et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B (2010)
Determination of the local contact potential difference of PTCDA on NaCl: a comparison of techniques
S. A. Burke et al.
NANOTECHNOLOGY (2009)
Equivalent point-mass models of continuous atomic force microscope probes
John Melcher et al.
APPLIED PHYSICS LETTERS (2007)
Reconstruction of electrostatic force microscopy images
E Strassburg et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2005)
Development of low noise cantilever deflection sensor for multienvironment frequency-modulation atomic force microscopy
T Fukuma et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2005)
Accuracy and resolution limits of Kelvin probe force microscopy -: art. no. 125424
U Zerweck et al.
PHYSICAL REVIEW B (2005)
Quantitative force measurements using frequency modulation atomic force microscopy - theoretical foundations
JE Sader et al.
NANOTECHNOLOGY (2005)
General theory of microscopic dynamical response in surface probe microscopy: From imaging to dissipation
LN Kantorovich et al.
PHYSICAL REVIEW LETTERS (2004)
Surface potential measurements by the dissipative force modulation method
T Fukuma et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2004)
Amplitude or frequency modulation-detection in Kelvin probe force microscopy
T Glatzel et al.
APPLIED SURFACE SCIENCE (2003)
Measurement of conservative and dissipative tip-sample interaction forces with a dynamic force microscope using the frequency modulation technique -: art. no. 075402
H Hölscher et al.
PHYSICAL REVIEW B (2001)
Using higher flexural modes in non-contact force microscopy
O Pfeiffer et al.
APPLIED SURFACE SCIENCE (2000)
Electrostatic energy calculation for the interpretation of scanning probe microscopy experiments
LN Kantorovich et al.
JOURNAL OF PHYSICS-CONDENSED MATTER (2000)
Share Paper
