Related references
Note: Only part of the references are listed.Error analysis of the crystal orientations obtained by the dictionary approach to EBSD indexing
Farangis Ram et al.
ULTRAMICROSCOPY (2017)
Application of forward models to crystal orientation refinement
Saransh Singh et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2017)
Quantitative electron backscatter diffraction (EBSD) data analyses using the dictionary indexing (DI) approach: Overcoming indexing difficulties on geological materials
Katharina Marquardt et al.
AMERICAN MINERALOGIST (2017)
High Spatial Resolution Evaluation of Residual Stresses in Shot Peened Specimens Containing Sharp and Blunt Notches by Micro-hole Drilling, Micro-slot Cutting and Micro-X-ray Diffraction Methods
B. Winiarski et al.
EXPERIMENTAL MECHANICS (2016)
A Xe + Plasma FIB Milling and Lift-out Approach for Site-specific Preparation of Large Volume Blocks for 3D-EBSD
B. Winiarski et al.
MICROSCOPY AND MICROANALYSIS (2016)
Large volume serial section tomography by Xe Plasma FIB dual beam microscopy
T. L. Burnett et al.
ULTRAMICROSCOPY (2016)
Effect of shot peening on metastable austenitic stainless steels
G. Fargas et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
A Dictionary Approach to Electron Backscatter Diffraction Indexing
Yu H. Chen et al.
MICROSCOPY AND MICROANALYSIS (2015)
Introduction and comparison of new EBSD post-processing methodologies
Stuart I. Wright et al.
ULTRAMICROSCOPY (2015)
Characterization of Plastic Deformation Induced by Shot-Peening in a Ni-Base Superalloy
O. M. D. M. Messe et al.
JOM (2014)
Evaluating surface deformation and near surface strain hardening resulting from shot peening a tempered martensitic steel and application to low cycle fatigue
K. A. Soady et al.
INTERNATIONAL JOURNAL OF FATIGUE (2013)
Dynamical Electron Backscatter Diffraction Patterns. Part I: Pattern Simulations
Patrick G. Callahan et al.
MICROSCOPY AND MICROANALYSIS (2013)
The effect of shot peening on the microstructure and properties of a near-alpha titanium alloy following high temperature exposure
Meurig Thomas et al.
ACTA MATERIALIA (2012)
Assessment of surface hardening effects from shot peening on a Ni-based alloy using electron backscatter diffraction techniques
D. J. Child et al.
ACTA MATERIALIA (2011)
Grain detection from 2d and 3d EBSD data-Specification of the MTEX algorithm
Florian Bachmann et al.
ULTRAMICROSCOPY (2011)
A novel pole figure inversion method: specification of the MTEX algorithm
R. Hielscher et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2008)
Quantification of plastic strain of stainless steel and nickel alloy by electron backscatter diffraction
M Kamaya et al.
ACTA MATERIALIA (2006)
Surface nanocrystallization of 316L stainless steel induced by ultrasonic shot peening
G Liu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2000)