Journal
TRIBOLOGY LETTERS
Volume 47, Issue 2, Pages 261-271Publisher
SPRINGER/PLENUM PUBLISHERS
DOI: 10.1007/s11249-012-9979-7
Keywords
Mineral base stocks; Marine Diesel engine; Surface tension; Viscosity; Lubricant degradation; Piston rings
Categories
Ask authors/readers for more resources
The influence of sulphuric acid, H2SO4, on the physical and chemical behaviour of marine Diesel engine lubricant base oils was investigated. To understand the basic interaction of H2SO4 with the lubricant film, the saturated hydrocarbon squalane, C30H62, was chosen as a simple model oil in addition to a fully formulated lubricant and its corresponding API Group I base oil HVI160B. To understand droplet formation in the lubricant, the interfacial tension between aqueous H2SO4 (0-98 %w/w) and C30H62 measured in a previous study (Sautermeister et al., Tribology International, 38th Leeds-Lyon Symposium on Tribology, 2011) and is compared with three different API Group I base oils. Interfacial tension decreases with increasing acid concentration, but is much lower for the base oil. Both oils were emulsified with a constant volume fraction of aqueous H2SO4. The droplet size was smaller and more distinct for the base oil under the same shearing conditions and the emulsions with base oil were are more stable. The concentration of the dispersed phase had no significant influence on the viscosity of the emulsions compared to the viscosity of the bulk oil alone. In addition to the physical measurements, chemical reaction between H2SO4 and the API Group I base oil HVI160B was observed yielding bituminous matter which appears to be a complex emulsion. The critical acid concentration for the formation of bitumen was found to be 40 %w/w. Between 50 and 80 %w/w, bitumen was formed spontaneously at 85 A degrees C and above 85 %w/w, bitumen was formed spontaneously at room temperature. The observed concentrations for bitumen formation correlate well with the first and second dissociation steps of H2SO4. HSO4 (-) ions are likely to be the driving force for bitumen formation. Finally, the viscosity characteristics of two different bitumen were measured. Both were found to exhibit shear thinning and the one formed with highly concentrated H2SO4 created a solid deposit on the measurement equipment above 120 A degrees C.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available