Journal
TRIBOLOGY INTERNATIONAL
Volume 66, Issue -, Pages 35-43Publisher
ELSEVIER SCI LTD
DOI: 10.1016/j.triboint.2013.04.002
Keywords
TiCN cermets; Three-body abrasion; Surface analysis; Wear modeling
Categories
Funding
- Grand Survey on Land and Nature Sources of China
- China Geological Survey [1212010916026]
- Ph.D. Programs Foundation by Ministry of Education of China [20100022110002]
- Excellent Adviser Foundation in China University of Geosciences from the Fundamental Research Funds for the Central Universities
- Key Laboratory on Deep GeoDrilling Technology of the Ministry of Land and Resources [NLSD201222]
Ask authors/readers for more resources
The wear behavior of TiCN cermets was investigated under water-based slurries with coarse angular abrasives of SiC, Al2O3 and SiO2, through a modified ASTM B611 wet-sand rubber-rimmed wheel test system. Under the same conditions, the wear rate increased with increasing abrasive hardness and mass fraction. With increasing sliding distance, under lower abrasive fraction the wear rate increased very slowly, but under higher abrasive fraction it initially increased rapidly, then became steady and even dropped down. Through observing the abraded sample surfaces by 3D white-light interfering surface profiler, the wear mechanism of TiCN cermets was proposed. (C) 2013 Elsevier Ltd. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available