Journal
THIN SOLID FILMS
Volume 531, Issue -, Pages 354-361Publisher
ELSEVIER SCIENCE SA
DOI: 10.1016/j.tsf.2013.01.016
Keywords
Titanium; Electron microscopy; Fragmentation testing; Temperature; Adhesion layer; Interfaces
Categories
Funding
- Austrian Science Fund (FWF) [P22684-N20]
Ask authors/readers for more resources
Titanium layers are used to promote adhesion between polymer substrates for flexible electronics and the Cu or Au conducting lines. Good adhesion of conducting lines in flexible circuits is critical in improving circuit performance and increasingcircuit lifetime. Nominally 50 nm thick Ti films on polyimide (PI) are investigated by fragmentation testing under uniaxial tensile load in the as-deposited state, at 350 degrees C, and after annealing. The cracking and buckling of the films show clear differences between the as-deposited and the thermally treated samples, cracks are much straighter and buckles are smaller following heat treatment. These changes are correlated to a drop in adhesion of the samples following heat treatment. Adhesion values are determined from the buckle dimensions using a total energy approach as described in the work of Cordill et al. (Acta Mater. 2010). Cross-sectional transmission electron microscopy of the Ti/PI interface found evidence of a similar to 5 nm thick interlayer between the largely columnar Ti and the amorphous PI. This interlayer is amorphous in the as-deposited state but nano-crystalline in those coatings tested at elevated temperature or annealed. It is put forward that this alteration of the interfacial structure causes the reduced adhesion. (C) 2013 Elsevier B. V. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available