Friction stir welding of dissimilar A319 and A356 aluminium cast alloys

In the present investigation, the microstructure and mechanical characteristics of dissimilar A319 and A356 cast Al alloys plates joined by friction stir welding (FSW) were evaluated. The effect of tool rotational and welding speeds as well as the post-weld heat treatment (PWHT) on such properties was investigated. Post-weld heat treatment was carried out at a solutionising temperature of 540 degrees C for 12 h followed by aging at 155 degrees C for 6 h. For the as welded specimens, the welded zone (WZ) exhibited higher hardness values when compared with the A319 and A356 parent alloys. The peak hardness at the WZ was found to increase by increasing the tool rotational speed and/or reducing the welding speed. In contrast, the post-weld heat treated (PWHTed) specimens exhibited lower hardness values at the WZ than the parent alloys. For PWHTed specimens, the peak hardness at the WZ was found to decrease by increasing the tool rotational speed and/or reducing the welding speed. Tensile tests results demonstrate that, for the as welded specimens, the tensile fracture took place on A356 side where the hardness was minimal. While for PWHTed specimens, the fracture took place at the WZ. Increasing the tool rotational speed reducing both tensile and yield strengths, but increases the ductility of the joint.