Related references
Note: Only part of the references are listed.Suppression of Type IV fracture and improvement of creep strength of 9Cr steel welded joints by boron addition
Fujio Abe et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2007)
Type IV cracking in ferritic power plant steels
J. A. Francis et al.
MATERIALS SCIENCE AND TECHNOLOGY (2006)
Suppressing type IV failure via modification of heat affected zone microstructures using high boron content in 9Cr heat resistant steel welded joints
M Kondo et al.
SCIENCE AND TECHNOLOGY OF WELDING AND JOINING (2006)
Influence of heat treatment on formation behavior of boron nitride inclusions in P122 heat resistant steel
Kazuyuki Sakuraya et al.
ISIJ INTERNATIONAL (2006)
Improving the creep properties of 9Cr-3W-3Co-NbV steels and their weld joints by the addition of boron
SK Albert et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2005)
Simulation of role of precipitate in creep void occurrence in heat affected zone of high Cr ferritic heat resistant steels
DJ Li et al.
SCIENCE AND TECHNOLOGY OF WELDING AND JOINING (2005)
Investigation of precipitation behavior in a weld deposit of 11Cr-2W ferritic steel
DJ Li et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2005)
Stabilization of martensitic microstructure in advanced 9Cr steel during creep at high temperature
F Abe et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)
Metallography of 9Cr steel power plant weld microstructures
E Letofsky et al.
SCIENCE AND TECHNOLOGY OF WELDING AND JOINING (2004)
Microstructure and creep strength of welds in advanced ferritic power plant steels
F Abe et al.
SCIENCE AND TECHNOLOGY OF WELDING AND JOINING (2004)
Analysis of factors affecting type IV cracking in welded joints of high chromium ferritic heat resistant steels
D Li et al.
SCIENCE AND TECHNOLOGY OF WELDING AND JOINING (2003)
Variation in the Type IV cracking behaviour of a high Cr steel weld with post weld heat treatment
SK Albert et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2003)
The morphology and crystallography of lath martensite in Fe-C alloys
S Morito et al.
ACTA MATERIALIA (2003)
Microstructural investigations on Type IV cracking in a high Cr steel
SK Albert et al.
ISIJ INTERNATIONAL (2002)
Degradation of creep strength in welded joint of 9%Cr steel
M Matsui et al.
ISIJ INTERNATIONAL (2001)
Share Paper
