Related references
Note: Only part of the references are listed.Investigation on three-body abrasive wear of ferritic steels, austenitic steel, and low-carbon steel
S. B. Wesley et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2012)
Influence of fibre orientation on three-body abrasive wear behaviour of unidirectional carbon fibre-reinforced polyetherimide composite
A. P. Harsha et al.
JOURNAL OF MATERIALS SCIENCE (2011)
An investigation on low stress abrasive wear characteristics of high performance engineering thermoplastic polymers
A. P. Harsha
WEAR (2011)
Some remarks on particle size effects on the abrasion of a range of Fe based alloys
J. G. Chacon-Nava et al.
TRIBOLOGY INTERNATIONAL (2010)
Three body abrasive wear characteristics of plasma sprayed conventional and nanostructured Al2O3-13%TiO2 coatings
W. Tian et al.
TRIBOLOGY INTERNATIONAL (2010)
Abrasive wear resistance of some commercial abrasion resistant steels evaluated by laboratory test methods
Jose Rendon et al.
WEAR (2009)
Particle motion and modes of wear in the dry sand-rubber wheel abrasion test
S. M. Nahvi et al.
WEAR (2009)
High-stress abrasive wear response of 0.2% carbon dual phase steel: Effects of microstructural features and experimental conditions
O. P. Modi et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)
Increasing the abrasion resistance without decreasing the toughness of WC-Co of a wide range of compositions and grain sizes
S. Luyckx et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2007)
Abrasive wear of aluminium alloys rubbed against sand
K. Elleuch et al.
WEAR (2006)
Effect of indenter geometry and relationship between abrasive wear and hardness in early stage of repetitive sliding
S Mezlini et al.
WEAR (2006)
Simulation of three-dimensional abrasive particles
DV De Pellegrin et al.
WEAR (2005)
A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions
MS Bingley et al.
WEAR (2005)
Abrasive wear of high speed steels: Influence of abrasive particles and primary carbides on wear resistance
E Badisch et al.
TRIBOLOGY INTERNATIONAL (2003)
Two-body and three-body abrasive wear behaviour of polyaryletherketone composites
AP Harsha et al.
POLYMER TESTING (2003)
Three-body abrasive wear behaviour of polyaryletherketone composites
AP Harsha et al.
WEAR (2003)
The effects of particle characteristics on three-body abrasive wear
GB Stachowiak et al.
WEAR (2001)
Abrasion of mild steel in wet and dry conditions with the rubber and steel wheel abrasion apparatus
S Wirojanupatump et al.
WEAR (2000)
Share Paper
