Related references
Note: Only part of the references are listed.Research of thermal response simulation and mold structure optimization for rapid heat cycle molding processes, respectively, with steam heating and electric heating
Guilong Wang et al.
MATERIALS & DESIGN (2010)
Parallel three-dimensional simulation of the injection molding process
B. J. Araujo et al.
INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN FLUIDS (2009)
Numerical Simulations and Verifications of Cyclic and Transient Temperature Variations in Injection Molding Process
Hai-Mei Li et al.
POLYMER-PLASTICS TECHNOLOGY AND ENGINEERING (2009)
Fully-Coupled Numerical Analysis of High-Frequency Induction Heating for Thin-Wall Injection Molding
Hyeju Eom et al.
POLYMER-PLASTICS TECHNOLOGY AND ENGINEERING (2009)
Research on a New Variotherm Injection Molding Technology and its Application on the Molding of a Large LCD Panel
Guilong Wang et al.
POLYMER-PLASTICS TECHNOLOGY AND ENGINEERING (2009)
Rapid Thermal Cycling of Injection Molds: An Overview on Technical Approaches and Applications
Donggang Yao et al.
ADVANCES IN POLYMER TECHNOLOGY (2008)
Simulation of infrared rapid surface heating for injection molding
Pei-Chi Chang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2006)
Three-dimensional finite element method for the filling simulation of injection molding
Tie Geng et al.
ENGINEERING WITH COMPUTERS (2006)
Numerical simulation for injection molding with a rapidly heated mold, Part I: Flow simulation for thin wall parts
Keun Park et al.
POLYMER-PLASTICS TECHNOLOGY AND ENGINEERING (2006)
Coupled part and mold temperature simulation for injection molding based on solid geometry
Wei Cao et al.
POLYMER-PLASTICS TECHNOLOGY AND ENGINEERING (2006)
Development of rapid heating and cooling systems for injection molding applications
DG Yao et al.
POLYMER ENGINEERING AND SCIENCE (2002)
A new concept of active temperature control for an injection molding process using infrared radiation heating
T Saito et al.
POLYMER ENGINEERING AND SCIENCE (2002)
Development of an expert system for the determination of injection moulding parameters of thermoplastic materials:: EX-PIMM
AT Bozdana et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2002)
Increasing flow length in thin wall injection molding using a rapidly heated mold
DG Yao et al.
POLYMER-PLASTICS TECHNOLOGY AND ENGINEERING (2002)
Numerical simulation of mold filling in injection molding using a three-dimensional finite volume approach
RY Chang et al.
INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN FLUIDS (2001)
Three-dimensional filling and post-filling simulation of polymer injection molding
F Ilinca et al.
INTERNATIONAL POLYMER PROCESSING (2001)
Share Paper
