Related references
Note: Only part of the references are listed.Three-Dimensional Numerical Analysis of Injection-Compression Molding Process
Jae-Yun Ho et al.
POLYMER ENGINEERING AND SCIENCE (2012)
Injection Molding and Injection Compression Molding of Thin-Walled Light-Guided Plates with V-Grooved Microfeatures
Ming-Shyan Huang et al.
JOURNAL OF APPLIED POLYMER SCIENCE (2011)
An experimental study on the effects of injection-molding types for the birefringence distribution in polycarbonate discs
Inki Min et al.
KOREA-AUSTRALIA RHEOLOGY JOURNAL (2011)
Micro Replication by Injection-Compression Molding
M. Rohde et al.
INTERNATIONAL POLYMER PROCESSING (2009)
Residual stresses and birefringence in injection molding of amorphous polymers: Simulation and comparison with experiment
AI Isayev et al.
JOURNAL OF POLYMER SCIENCE PART B-POLYMER PHYSICS (2006)
Effect of process parameters on injection compression molding of pickup lens
WB Young
APPLIED MATHEMATICAL MODELLING (2005)
Birefringence prediction of optical media
BF Fan et al.
POLYMER ENGINEERING AND SCIENCE (2004)
Residual thermal birefringence in freely quenched plates of amorphous polymers: Simulation and experiment
GD Shyu et al.
JOURNAL OF POLYMER SCIENCE PART B-POLYMER PHYSICS (2003)
Simulation of injection-compression molding for optical media
BF Fan et al.
POLYMER ENGINEERING AND SCIENCE (2003)
Numerical prediction of residual stresses and birefringence in injection/compression molded center-gated disk. Part II: Effects of processing conditions
YB Lee et al.
POLYMER ENGINEERING AND SCIENCE (2002)
Simulation of injection-compression molding process, part 3: Effect of process conditions on part birefringence
SC Chen et al.
ADVANCES IN POLYMER TECHNOLOGY (2002)
Photoviscoelastic behavior of amorphous polymers during transition from the glassy to rubbery state
GD Shyu et al.
JOURNAL OF POLYMER SCIENCE PART B-POLYMER PHYSICS (2001)
25 Gbyte read-only memory disk by injection-compression molding process
T Imai et al.
JAPANESE JOURNAL OF APPLIED PHYSICS PART 1-REGULAR PAPERS SHORT NOTES & REVIEW PAPERS (2001)
The effects of compression pressure on injection compression molding
CM Chen et al.
INTERNATIONAL POLYMER PROCESSING (2000)
Share Paper
