Related references
Note: Only part of the references are listed.Effects of Prior Aging at 288°C in Air and in Argon Environments on Creep Response of PMR-15 Neat Resin
M. B. Ruggles-Wrenn et al.
JOURNAL OF APPLIED POLYMER SCIENCE (2009)
Rate Dependence and Short-Term Creep Behavior of a Thermoset Polymer at Elevated Temperature
C. M. Falcone et al.
JOURNAL OF PRESSURE VESSEL TECHNOLOGY-TRANSACTIONS OF THE ASME (2009)
Impression creep of a Sn60Pb40 alloy: the effect of electric current
Rong Chen et al.
JOURNAL OF PHYSICS D-APPLIED PHYSICS (2008)
The rate (time)-dependent mechanical behavior of the PMR-15 thermoset polymer at elevated temperature
A. J. W. McClung et al.
POLYMER TESTING (2008)
Impression creep behavior of cast Pb-Sb alloys
R. Mahmudi et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2007)
Impression creep of a Mg-8Zn4Al-0.5Ca alloy
LL Peng et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
Impression creep of Sn3.5Ag eutectic alloy
FQ Yang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
A mechanics-induced complication of impression creep and its solution: application to Sn-3.5Ag solder
D Pan et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)
Elastic-plastic and failure properties of a unidirectional carbon/PMR-15 composite at room and elevated temperatures
G Odegard et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2000)