Electrospinning of Heated Gelatin-Sodium Alginate-Water Solutions

Most polymers that are electrospun are dissolved in a solvent and are spun at ambient temperature. Gelatin, a natural polymer, has excellent potential in medical applications as a biodegradable polymer, especially when combined with sodium alginate. Unfortunately, gelatin/water or gelatin/sodium alginate/water solutions cannot be electrospun at ambient temperature without the incorporation of substances that are considered potentially toxic to the human body, such as acetic acid. In this study, gelatin/water solutions with and without sodium alginate were successfully electrospun without the use of additional solvents by using heated water solutions. The effect of electrospinning parameters such as solution concentration and applied voltage on the nanofiber morphology of these solutions was studied. These nanofibers from heated gelatin/water solutions exhibited good morphology with an average size of 291 +/- 67 nm at 18% concentration to 414 +/- 52 nm at 20% concentration. Similar sizes were observed when sodium alginate was incorporated into the gelatin/water solutions, although the relationship was dependent upon the amount of sodium alginate in the solution as well as the total concentration. Typically, these nanofibers containing sodium alginate were produced at a lower gelatin concentration compared with the gelatin/water nanofibers because of the increase of viscosity and conductivity of the solutions due to the addition of the highly viscous and conductivity sodium alginate. POLYM. ENG. SCI., 49:1616-1620, 2009. (C) 2009 Society of Plastics Engineers