Related references
Note: Only part of the references are listed.Surface engineering analysis of detonation-gun sprayed Cr3C2-NiCr coating under high-temperature oxidation and oxidation-erosion environments
Manpreet Kaur et al.
SURFACE & COATINGS TECHNOLOGY (2011)
High temperature oxidation studies of detonation-gun-sprayed Cr3C2-NiCr coating on Fe- and Ni-based superalloys in air under cyclic condition at 900°C
Subhash Kamal et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2009)
The role of microstructure in the mechanism of high velocity erosion of Cr3C2-NiCr thermal spray coatings: Part 1-As-sprayed coatings
S. Matthews et al.
SURFACE & COATINGS TECHNOLOGY (2009)
Hot corrosion behavior of detonation gun sprayed Cr3C2-NiCr coatings on Ni and Fe-based superalloys in Na2SO4-60%V2O5 environment at 900°C
Subhash Kamal et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2008)
Performance evaluation of several commercial alloys in a reducing environment
Y. Liu
JOURNAL OF POWER SOURCES (2008)
Oxidation and hot corrosion behavior of sputtered nanocrystalline coating of superalloy K52
F. Wang et al.
THIN SOLID FILMS (2008)
Microstructure dependent erosion in Cr3C2-20(NiCr) coating deposited by a detonation gun
J. K. N. Murthy et al.
SURFACE & COATINGS TECHNOLOGY (2007)
Investigations on role of plasma sprayed NiCrAlY and Ni-20Cr coatings to combat hot corrosion
H. Singh et al.
MATERIALS SCIENCE AND TECHNOLOGY (2007)
Comparative study of Cr3C2-NiCr coatings obtained by HVOF and hard chromium coatings
J. M. Guilemany et al.
CORROSION SCIENCE (2006)
Microstructural characterization and abrasive wear performance of HVOF sprayed Cr3C2-NiCr coating
Gang-Chang Ji et al.
SURFACE & COATINGS TECHNOLOGY (2006)
Mechanical and microstructural properties of HVOF sprayed WC-Co and Cr3C2-NiCr coatings on the boiler tube steels using LPG as the fuel gas
HS Sidhu et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Long-term carbide development in high-velocity oxygen fuel/high-velocity air fuel Cr3C2-NiCr coatings heat treated at 900°C
S Matthews et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2004)
The influence of temperature on the wear of Cr3C2-25(Ni2OCr) coating -: comparison between nanocrystalline grains and conventional grains
M Roy et al.
WEAR (2004)
Structure and wear behaviour of HVOF sprayed Cr3C2-NiCr and WC-Co coatings
T Sahraoui et al.
MATERIALS & DESIGN (2003)
Dominant effect of carbide rebounding on the carbon loss during high velocity oxy-fuel spraying of Cr3C2-NiCr
CJ Li et al.
THIN SOLID FILMS (2002)
Role of heat treatments in the improvement of the sliding wear properties of Cr3C2-NiCr coatings
JM Guilemany et al.
SURFACE & COATINGS TECHNOLOGY (2002)
Hot corrosion of Fe3Al
D Das et al.
JOURNAL OF MATERIALS SCIENCE (2002)
Part II:: tribological performance of Cr3C2-25% NiCr reactive plasma sprayed coatings deposited at different pressures
MH Staia et al.
SURFACE & COATINGS TECHNOLOGY (2001)
A comparative study of high-temperature erosion wear of plasma-sprayed NiCrBSiFe and WC-NiCrBSiFe coatings under simulated coal-fired boiler conditions
VH Hidalgo et al.
TRIBOLOGY INTERNATIONAL (2001)
High-temperature oxidation behavior of iron-chromium-aluminum alloys
SE Sadique et al.
OXIDATION OF METALS (2000)
High-temperature corrosion of recuperators used in steel mills
BG Seong et al.
SURFACE & COATINGS TECHNOLOGY (2000)
The failure of protective oxides on plasma-sprayed NiCrAlY overlay coatings
P Niranatlumpong et al.
OXIDATION OF METALS (2000)