4.6 Article Proceedings Paper

Corrosion of Ga-doped Sn-0.7Cu Solder in Simulated Marine Atmosphere

Related references

Note: Only part of the references are listed.
Article Chemistry, Physical

Structural properties of pulsed laser deposited SnOx thin films

E. Fazio et al.

APPLIED SURFACE SCIENCE (2011)

Article Engineering, Electrical & Electronic

Tin Whisker Growth on NdSn3 Powder

Hong-Chang Shi et al.

JOURNAL OF ELECTRONIC MATERIALS (2011)

Article Engineering, Multidisciplinary

TEM observation of tin whisker

Liu Meng et al.

SCIENCE CHINA-TECHNOLOGICAL SCIENCES (2011)

Article Materials Science, Multidisciplinary

Effect of Ag addition on the corrosion properties of Sn-based solder alloys

Q. V. Bui et al.

MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION (2010)

Article Chemistry, Physical

Spontaneous growth of whiskers on RE-bearing intermetallic compounds of Sn-RE, In-RE, and Pb-RE

Meng Liu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2009)

Article Engineering, Electrical & Electronic

Electromigration-Induced Failure of Ni/Cu Bilayer Bond Pads Joined with Sn(Cu) Solders

Y. H. Hsiao et al.

JOURNAL OF ELECTRONIC MATERIALS (2009)

Article Engineering, Electrical & Electronic

Tin Whisker Growth on the Surface of Sn-0.7Cu Lead-Free Solder with a Rare Earth (Nd) Addition

Meng Liu et al.

JOURNAL OF ELECTRONIC MATERIALS (2009)

Article Engineering, Electrical & Electronic

Generation of Tin(II) Oxide Crystals on Lead-Free Solder Joints in Deionized Water

Hong Chang et al.

JOURNAL OF ELECTRONIC MATERIALS (2009)

Article Materials Science, Multidisciplinary

Observations of continuous tin whisker growth in NdSn3 intermetallic compound

Ai-Ping Xian et al.

JOURNAL OF MATERIALS RESEARCH (2009)

Article Engineering, Electrical & Electronic

Tin whisker growth on bulk Sn-Pb eutectic doping with Nd

Meng Liu et al.

MICROELECTRONICS RELIABILITY (2009)

Article Materials Science, Multidisciplinary

Corrosion characterization of tin-lead and lead free solders in 3.5 wt.% NaCl solution

Dezhi Li et al.

CORROSION SCIENCE (2008)

Article Engineering, Mechanical

Effect of corrosion on the low cycle fatigue behavior of Sn-4.0Ag-0.5Cu lead-free solder joints

C. Andersson et al.

INTERNATIONAL JOURNAL OF FATIGUE (2008)

Article Materials Science, Multidisciplinary

Surface oxidation of molten Sn-0.07 wt% P in air at 280 degrees C

Ai-Ping Xian et al.

JOURNAL OF MATERIALS RESEARCH (2008)

Article Engineering, Electrical & Electronic

Oxidation behavior of molten tin doped with phosphorus

Ai-Ping Xian et al.

JOURNAL OF ELECTRONIC MATERIALS (2007)

Article Materials Science, Coatings & Films

Degradation of solderability of electroless nickel by phosphide particles

Jian-Jun Guo et al.

SURFACE & COATINGS TECHNOLOGY (2007)

Article Engineering, Manufacturing

Sn corrosion and its influence on whisker growth

J. W. Osenbach et al.

IEEE TRANSACTIONS ON ELECTRONICS PACKAGING MANUFACTURING (2007)

Article Engineering, Electrical & Electronic

Comparative study of wetting behavior and mechanical properties (microhardness) of Sn-Zn and Sn-Pb solders

Rashed Adnan Islam et al.

MICROELECTRONICS JOURNAL (2006)

Article Materials Science, Multidisciplinary

Electrochemical corrosion study of Pb-free solders

BY Wu et al.

JOURNAL OF MATERIALS RESEARCH (2006)

Review Materials Science, Multidisciplinary

Interfacial reactions between lead-free solders and common base materials

T Laurila et al.

MATERIALS SCIENCE & ENGINEERING R-REPORTS (2005)

Article Engineering, Electrical & Electronic

Cyclic softening of the Sn-3.8Ag-0.7Cu lead-free solder alloy with equiaxed grain structure

QL Zeng et al.

JOURNAL OF ELECTRONIC MATERIALS (2005)

Article Materials Science, Multidisciplinary

Corrosion of tin alloys in sulfuric and nitric acids

M Mori et al.

CORROSION SCIENCE (2002)

Article Electrochemistry

Anode properties of amorphous 50SiO•50SnO powders synthesized by mechanical milling

H Morimoto et al.

ELECTROCHEMICAL AND SOLID STATE LETTERS (2001)

Review Materials Science, Multidisciplinary

Lead-free solders in microelectronics

M Abtew et al.

MATERIALS SCIENCE & ENGINEERING R-REPORTS (2000)