Microstructures, Mechanical and Chemical Properties of TLP-Bonded Joints in a Duplex Stainless Steel with Amorphous Ni-Based Insert Alloys

The changes in tensile strength and pitting corrosion resistance of transient liquid-phase (TLP)-bonded joints for a duplex stainless steel with MBF-80, MBF-30, and MBF-35 as functions of holding time and filler were interpreted with respect to the bond microstructure. Using MBF-80 after 300 seconds, the fracture strength of the joint reached the maximum value. The failure was dependent on the interplay between the reduction in residual liquid and the increase in interface precipitates. After 3600 seconds, the joint strength had the minimum value. At the same conditions, the tensile strength for MBF-80 was low compared with MBF-35 and MBF-30. In contrast with the tensile strength, the joint produced with MBF-80 for 3600 seconds exhibited the best corrosion resistance. Among the fillers used, the corrosion resistance of the joint using MBF-80 close to that of the substrate could be related intimately to the existence of Cr in this filler.