Related references
Note: Only part of the references are listed.Ct-based finite element models can be used to estimate experimentally measured failure loads in the proximal femur
Janne E. M. Koivumaki et al.
BONE (2012)
Orientation of orthotropic material properties in a femur FE model: A method based on the principal stresses directions
T. San Antonio et al.
MEDICAL ENGINEERING & PHYSICS (2012)
Finite element prediction of proximal femur fracture pattern based on orthotropic behaviour law coupled to quasi-brittle damage
Ridha Hambli et al.
MEDICAL ENGINEERING & PHYSICS (2012)
Robust QCT/FEA Models of Proximal Femur Stiffness and Fracture Load During a Sideways Fall on the Hip
Dan Dragomir-Daescu et al.
ANNALS OF BIOMEDICAL ENGINEERING (2011)
Multiscale prediction of crack density and crack length accumulation in trabecular bone based on neural networks and finite element simulation
Ridha Hambli
INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN BIOMEDICAL ENGINEERING (2011)
Patient-Specific Finite-Element Analyses of the Proximal Femur with Orthotropic Material Properties Validated by Experiments
Nir Trabelsi et al.
JOURNAL OF BIOMECHANICAL ENGINEERING-TRANSACTIONS OF THE ASME (2011)
The human proximal femur behaves linearly elastic up to failure under physiological loading conditions
Mateusz Maria Juszczyk et al.
JOURNAL OF BIOMECHANICS (2011)
Damage accumulation in vertebral trabecular bone depends on loading mode and direction
Uwe Wolfram et al.
JOURNAL OF BIOMECHANICS (2011)
Apparent damage accumulation in cancellous bone using neural networks
Ridha Hambli
JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS (2011)
Simulation of orthotropic microstructure remodelling of cancellous bone
Piotr Kowalczyk
JOURNAL OF BIOMECHANICS (2010)
The effect of impact direction on the structural capacity of the proximal femur during falls
Catherine M. Ford et al.
JOURNAL OF BONE AND MINERAL RESEARCH (2010)
Does femoral strain distribution coincide with the occurrence of cervical versus trochanteric hip fractures? An experimental finite element study
Janne E. M. Koivumaki et al.
MEDICAL & BIOLOGICAL ENGINEERING & COMPUTING (2010)
Some factors that affect the comparison between isotropic and orthotropic inhomogeneous finite element material models of femur
Haisheng Yang et al.
MEDICAL ENGINEERING & PHYSICS (2010)
Predicting the yield of the proximal femur using high-order finite-element analysis with inhomogeneous orthotropic material properties
Zohar Yosibash et al.
PHILOSOPHICAL TRANSACTIONS OF THE ROYAL SOCIETY A-MATHEMATICAL PHYSICAL AND ENGINEERING SCIENCES (2010)
Hip fracture types in men and women change differently with age
David A. Tanner et al.
BMC GERIATRICS (2010)
A three-dimensional elastic plastic damage constitutive law for bone tissue
David Garcia et al.
BIOMECHANICS AND MODELING IN MECHANOBIOLOGY (2009)
Inhomogeneous, orthotropic material model for the cortical structure of long bones modelled on the basis of clinical CT or density data
Ralf Schneider et al.
COMPUTER METHODS IN APPLIED MECHANICS AND ENGINEERING (2009)
Numerical modeling of bone tissue adaptation-A hierarchical approach for bone apparent density and trabecular structure
P. G. Coelho et al.
JOURNAL OF BIOMECHANICS (2009)
Biomechanical study of mandible bone supporting a four-implant retained bridge Finite element analysis of the influence of bone anisotropy and foodstuff position
A. S. Bonnet et al.
MEDICAL ENGINEERING & PHYSICS (2009)
Bone strength at the distal radius can be estimated from high-resolution peripheral quantitative computed tomography and the finite element method
Joshua A. MacNeil et al.
BONE (2008)
An anatomical subject-specific FE-model for hip fracture load prediction
L. Duchemin et al.
COMPUTER METHODS IN BIOMECHANICS AND BIOMEDICAL ENGINEERING (2008)
Experimental validation of a finite element model of a human cadaveric tibia
Hans A. Gray et al.
JOURNAL OF BIOMECHANICAL ENGINEERING-TRANSACTIONS OF THE ASME (2008)
Postfailure modulus strongly affects microcracking and mechanical property change in human iliac cancellous bone: A study using a 2D nonlinear finite element method
Xiang Wang et al.
JOURNAL OF BIOMECHANICS (2008)
Subject-specific finite element models implementing a maximum principal strain criterion are able to estimate failure risk and fracture location on human femurs tested in vitro
Enrico Schileo et al.
JOURNAL OF BIOMECHANICS (2008)
Parametric subject-specific model for in vivo 3D reconstruction using bi-planar X-rays: application to the upper femoral extremity
A. Baudoin et al.
MEDICAL & BIOLOGICAL ENGINEERING & COMPUTING (2008)
Comparison of an inhomogeneous orthotropic and isotropic material models used for FE analyses
Vaclav Baca et al.
MEDICAL ENGINEERING & PHYSICS (2008)
Constitutive modelling of inelastic behaviour of cortical bone
Arturo N. Natali et al.
MEDICAL ENGINEERING & PHYSICS (2008)
Micromechanics-based conversion of CT data into anisotropic elasticity tensors, applied to FE simulations of a mandible
Christian Hellmich et al.
ANNALS OF BIOMEDICAL ENGINEERING (2008)
Quantifying anisotropy of trabecular bone from gray-level images
Zbislaw Tabor et al.
BONE (2007)
Proximal femoral density and geometry measurements by quantitative computed tomography: Association with hip fracture
X. Cheng et al.
BONE (2007)
Prediction of strength and strain of the proximal femur by a CT-based finite element method
Masahiko Bessho et al.
JOURNAL OF BIOMECHANICS (2007)
Reliable simulations of the human proximal femur by high-order finite element analysis validated by experimental observations
Zohar Yosibash et al.
JOURNAL OF BIOMECHANICS (2007)
Anisotropy of age-related toughness loss in human cortical bone: A finite element study
Ani Ural et al.
JOURNAL OF BIOMECHANICS (2007)
Subject-specific finite element models can accurately predict strain levels in long bones
Enrico Schileo et al.
JOURNAL OF BIOMECHANICS (2007)
3D femoral neck anteversion measurements based on the posterior femoral plane in ORTHODOC® system
Yeon Soo Lee et al.
MEDICAL & BIOLOGICAL ENGINEERING & COMPUTING (2006)
Re-evaluating the toughness of human cortical bone
Q. D. Yang et al.
BONE (2006)
Comparison of isotropic and orthotropic material property assignments on femoral finite element models under two loading conditions
L Peng et al.
MEDICAL ENGINEERING & PHYSICS (2006)
Comparison of micro-level and continuum-level voxel models of the proximal femur
E. Verhulp et al.
JOURNAL OF BIOMECHANICS (2006)
Subject-specific finite element models of long bones: An in vitro evaluation of the overall accuracy
Fulvia Taddei et al.
JOURNAL OF BIOMECHANICS (2006)
Evaluation of achievable registration accuracy of the femur during minimally invasive total hip replacement
FC Popescu et al.
MEDICAL & BIOLOGICAL ENGINEERING & COMPUTING (2005)
Trabecular bone microdamage and microstructural stresses under uniaxial compression
S Nagaraja et al.
JOURNAL OF BIOMECHANICS (2005)
Comparison of the elastic and yield properties of human femoral trabecular and cortical bone tissue
HH Bayraktar et al.
JOURNAL OF BIOMECHANICS (2004)
Relationships between material properties and CT scan data of cortical bone with and without metastatic lesions
TS Kaneko et al.
MEDICAL ENGINEERING & PHYSICS (2003)
A crack growth model for the simulation of fatigue in bone
D Taylor et al.
INTERNATIONAL JOURNAL OF FATIGUE (2003)
Concept and development of an orthotropic FE model of the proximal femur
DC Wirtz et al.
JOURNAL OF BIOMECHANICS (2003)
Equine cortical bone exhibits rising R-curve fracture mechanics
CL Malik et al.
JOURNAL OF BIOMECHANICS (2003)
Structure analysis of high resolution magnetic resonance Imaging of the proximal femur:: In vitro correlation with biomechanical strength and BMD
TM Link et al.
CALCIFIED TISSUE INTERNATIONAL (2003)
Tensile damage and its effects on cortical bone
SP Kotha et al.
JOURNAL OF BIOMECHANICS (2003)
Accuracy of CT-based thickness measurement of thin structures: Modeling of limited spatial resolution in all three dimensions
S Prevrhal et al.
MEDICAL PHYSICS (2003)
Comparison of in situ and in vitro CT scan-based finite element model predictions of proximal femoral fracture load
JH Keyak et al.
MEDICAL ENGINEERING & PHYSICS (2003)
Experimental validation of a microcracking-based toughening mechanism for cortical bone
D Vashishth et al.
JOURNAL OF BIOMECHANICS (2003)
Determination of orthotropic bone elastic constants using FEA and modal analysis
WR Taylor et al.
JOURNAL OF BIOMECHANICS (2002)
Trabecular bone adaptation with an orthotropic material model
Z Miller et al.
JOURNAL OF BIOMECHANICS (2002)
Anisotropic bone remodelling model based on a continuum damage-repair theory
M Doblare et al.
JOURNAL OF BIOMECHANICS (2002)
Improved prediction of proximal femoral fracture load using nonlinear finite element models
JH Keyak
MEDICAL ENGINEERING & PHYSICS (2001)
In vivo diffuse damage in human vertebral trabecular bone
D Vashishth et al.
BONE (2000)
Share Paper
