Related references
Note: Only part of the references are listed.Improvement of fatigue properties by shot peening for Mg-10Gd-3Y alloys under different conditions
W. C. Liu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
EXPERIMENTAL AND NUMERICAL STUDY OF SHOT PEENED THIN HARD-COATED COMPONENTS
S. Baragetti et al.
MECHANICS BASED DESIGN OF STRUCTURES AND MACHINES (2011)
An area-average approach to peening residual stress under multi-impacts using a three-dimensional symmetry-cell finite element model with plastic shots
Taehyung Kim et al.
MATERIALS & DESIGN (2010)
Some Inverse Problems in Penetration Mechanics
G. Ben-Dor et al.
MECHANICS BASED DESIGN OF STRUCTURES AND MACHINES (2010)
An analytical approach to relate shot peening parameters to Almen intensity
H. Y. Miao et al.
SURFACE & COATINGS TECHNOLOGY (2010)
Contact Analysis by Shape Optimization (CASO)
B. M. Kwak et al.
MECHANICS BASED DESIGN OF STRUCTURES AND MACHINES (2009)
The optimisation of shot peen forming processes
T. Wang et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2008)
Fatigue limits prediction of surface treated materials
H Guechichi et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
A process model for shot peen forming
T Wang et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Influence of shot peening on high cycle fatigue properties of the high-strength wrought magnesium alloy AZ80
P Zhang et al.
SCRIPTA MATERIALIA (2005)
Flexible sheet forming technology by double-sided simultaneous shot peen forming
R Kopp et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2002)
Relating Almen intensity to residual stresses induced by shot peening: a numerical approach
M Guagliano
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2001)
Share Paper
