Enhanced strength and ductility in particulate-reinforced aluminum matrix composites fabricated by flake powder metallurgy

Reinforcement agglomeration always leads to severe stress concentration and porosity, which is detrimental to the deformation ability and mechanical properties of particulate-reinforced metal matrix composites. In this study, uniform distribution of 32 vol%B4C has been achieved in B4C/Al composite by means of flake powder metallurgy (Flake PM), in which flake Al powder is used as the starting material. The flake Al powder exhibits higher apparent volume than spherical powders of the same mass, and thus can provide more space to accommodate the B4C particles. Therefore, compared with conventional PM, Flake PM can lead to more uniform distribution of B4C particles in the composite powder as well as in the consolidated composite. Meanwhile, the flake Al powder has a nano skin of Al2O3, which could be fractured and dispersed inside the fine matrix grains during consolidation, and were found to induce a higher normalized strain hardening rate for the composite during deformation. As a result, the Flake PM 32 vol%B4C/Al composite exhibits an ultimate tensile strength of 305 MPa and a uniform elongation of 6.6%, 63% stronger and 13% more ductile than its counterpart fabricated by conventional PM. (C) 2013 Elsevier B.V. All rights reserved.