Related references
Note: Only part of the references are listed.Optimization of wire electrical discharge machining (WEDM) process parameters using Taguchi method
S. S. Mahapatra et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2007)
Influence of machining parameters on surface roughness in finish cut of WEDM
Fuzhu Han et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2007)
Micro electrical discharge milling using deionized water as a dielectric fluid
Do Kwan Chung et al.
JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2007)
Plastic injection molding of high-aspect ratio micro-rods
Nan Shing Ong et al.
MATERIALS AND MANUFACTURING PROCESSES (2006)
Machining characteristics and optimization of machining parameters of SKH 57 high-speed steel using electrical-discharge machining based on Taguchi method
Yan-Cherng Lin et al.
MATERIALS AND MANUFACTURING PROCESSES (2006)
Micro wire EDM for high aspect ratio 3D microstructuring of ceramics and metals
A Schoth et al.
MICROSYSTEM TECHNOLOGIES-MICRO-AND NANOSYSTEMS-INFORMATION STORAGE AND PROCESSING SYSTEMS (2005)
A study to achieve a fine surface finish in Wire-EDM
YS Liao et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2004)
Study of specific discharge energy in WEDM and its application
YS Liao et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2004)
The effect of cutting parameters on wire crater sizes in wire EDM
N Tosun et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2003)
Development of microreplication process - Micromolding
S Yuan et al.
MATERIALS AND MANUFACTURING PROCESSES (2003)
Experimental investigation into shaping particle-reinforced material by WEDM-HS
ZN Guo et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2002)
High aspect ratio meso-scale parts enabled by wire micro-EDM
GL Benavides et al.
MICROSYSTEM TECHNOLOGIES (2002)
Study of the batch production of micro parts using the EDM process
FT Weng et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2002)
Surface roughness of sputtered silicon. I. Surface modeling
MY Ali et al.
MATERIALS AND MANUFACTURING PROCESSES (2001)
Surface roughness of sputtered silicon. II. Model verification
MY Ali et al.
MATERIALS AND MANUFACTURING PROCESSES (2001)
Experimental investigation of effects of cutting parameters on surface roughness in the WEDM process
MI Gökler et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2000)
High-aspect-ratio WC-Co microstructure produced by the combination of LIGA and micro-EDM
K Takahata et al.
MICROSYSTEM TECHNOLOGIES (2000)