4.7 Article

Diagenesis and reservoir quality of Miocene sandstones in the Vienna Basin, Austria

Journal

MARINE AND PETROLEUM GEOLOGY
Volume 25, Issue 8, Pages 681-695

Publisher

ELSEVIER SCI LTD
DOI: 10.1016/j.marpetgeo.2008.06.001

Keywords

Sandstone diagenesis; Reservoir quality; Carbonate cement; Quartz cement; Ductile lithic grains; Compaction; Illite-smectite ratio; Vienna Basin

Funding

  1. Hochschuljubilaumsstiftung der Stadt Wien [H-166/2001]

Ask authors/readers for more resources

A study of the diagenetic evolution of Neogene sandstones in the Vienna Basin (Austria) was undertaken to unravel the controls on reservoir quality. These rocks present a similar to 2000 m succession of relatively similar lithic arkoses with the deepest rocks buried progressively to nearly 3000 m and thus present an opportunity to study sequential diagenetic changes. The Neogene sandstones sit above Alpine allochthonous nappes and autochthonous Mesozoic sediments that include Jurassic source rocks. Oil has been produced from Badenian marine sandstones at about 1700 m but reservoir quality is marginal. Thirty-eight samples from 892 m to 2774 m were studied using petrography, XRD, SEM, microprobe, infrared spectroscopy and a range of modelling approaches. The sandstones contain abundant ductile grains and a variety of carbonate grains. The main eogenetic cements include clay coats, pyrite and possibly glauconite. The main mesogenetic cements include the dominant calcite, kaolinite and minor quartz. Smectite was replaced predominantly by illite with minor growth of grain-coating chlorite. Thermal histories for each sandstone sample were calibrated by modelling the degree of smectite to illite transformation. These sample-specific thermal histories were then used to model quartz precipitation revealing that quartz cement, the most important cement in many sandstones worldwide, is of negligible significance here because (I) there has been insufficient time since deposition, or (2) the geothermal gradient is not high enough or (3) calcite cement filled the pore space before quartz cement could grow. Instead porosity has been controlled by the abundance of detrital ductile (lithic) grains and the abundance of detrital carbonate grains which have been variably dissolved and reprecipitated as ferroan calcite cement. The highest porosity for a given depth decreases with increasing depth due to compactional processes. Porosity is highest for samples where both the detrital ductile grain and carbonate cement contents are low. The accumulation of oil in the middle part of the section has had no discernable effect on porosity since diagenesis is mostly controlled by compactional and carbonate recrystallisation processes and oil probably entered the reservoir late in the diagenetic sequence, after ductile compaction and growth of carbonate cements had already occurred. (C) 2008 Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available