Related references
Note: Only part of the references are listed.Biaxial elastic-viscoplastic behavior of Nafion membranes
Meredith N. Silberstein et al.
POLYMER (2011)
Constitutive response and mechanical properties of PFSA membranes in liquid water
Ahmet Kusoglu et al.
JOURNAL OF POWER SOURCES (2010)
Constitutive modeling of the rate, temperature, and hydration dependent deformation response of Nafion to monotonic and cyclic loading
Meredith N. Silberstein et al.
JOURNAL OF POWER SOURCES (2010)
A Multiphysics Model of PEM Fuel Cell Incorporating the Cell Compression Effects
Wonseok Yoon et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2010)
Osmotic Pressure of Water in Nafion®
Michael K Budinski et al.
TSINGHUA SCIENCE AND TECHNOLOGY (2010)
A review of accelerated stress tests of MEA durability in PEM fuel cells
Shengsheng Zhang et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2009)
Viscoelastic Stress Analysis of Constrained Proton Exchange Membranes Under Humidity Cycling
Yeh-Hung Lai et al.
JOURNAL OF FUEL CELL SCIENCE AND TECHNOLOGY (2009)
Fatigue and creep to leak tests of proton exchange membranes using pressure-loaded blisters
Yongqiang Li et al.
JOURNAL OF POWER SOURCES (2009)
Characterizing the fracture resistance of proton exchange membranes
Yongqiang Li et al.
JOURNAL OF POWER SOURCES (2008)
A time and hydration dependent viscoplastic model for polyelectrolyte membranes in fuel cells
Roham Solasi et al.
MECHANICS OF TIME-DEPENDENT MATERIALS (2008)
Mechanical behavior of fuel cell membranes under humidity cycles and effect of swelling anisotropy on the fatigue stresses
Ahmet Kusoglu et al.
JOURNAL OF POWER SOURCES (2007)
A degradation study of Nation proton exchange membrane of PEM fuel cells
Haolin Tang et al.
JOURNAL OF POWER SOURCES (2007)
On mechanical behavior and in-plane modeling of constrained PEM fuel cell membranes subjected to hydration and temperature cycles
Roham Solasi et al.
JOURNAL OF POWER SOURCES (2007)
Strain accumulation in polymer electrolyte membrane and membrane electrode assembly materials during a single hydration/dehydration cycle
Louis G. Hector et al.
JOURNAL OF FUEL CELL SCIENCE AND TECHNOLOGY (2007)
Mechanical response of fuel cell membranes subjected to a hygro-thermal cycle
Ahmet Kusoglu et al.
JOURNAL OF POWER SOURCES (2006)
Mechanical endurance of polymer electrolyte membrane and PEM fuel cell durability
Xinyu Huang et al.
JOURNAL OF POLYMER SCIENCE PART B-POLYMER PHYSICS (2006)
Coating internal stress measurement through the curvature method:: A geometry-based criterion delimiting the relevance of Stoney's formula
A Mézin
SURFACE & COATINGS TECHNOLOGY (2006)
Stresses in proton exchange membranes due to hygro-thermal loading
Yaliang Tang et al.
JOURNAL OF FUEL CELL SCIENCE AND TECHNOLOGY (2006)
Geometric and material nonlinearity during the deformation of micron-scale thin-film bilayers subject to thermal loading
YH Zhang et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2004)
The role of the sample shape and size on the internal stress induced curvature of thin-film substrate systems
N Guyot et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2004)
A theoretical study of membrane constraint in polymer-electrolyte fuel cells
AZ Weber et al.
AICHE JOURNAL (2004)
Elastic and elastic-plastic analysis of multilayer thin films: Closed-form solutions
YY Hu et al.
JOURNAL OF APPLIED PHYSICS (2004)
Structural recovery in a model epoxy: Comparison of responses after temperature and relative humidity jumps
Y Zheng et al.
MACROMOLECULES (2003)
Bimaterial curvature measurements for the CTE of adhesives: optimization, modeling, and stability
JH Yu et al.
JOURNAL OF ADHESION SCIENCE AND TECHNOLOGY (2003)
Thermal stresses in elastic multilayer systems
CH Hsueh
THIN SOLID FILMS (2002)
Deformation and structural stability of layered plate microstructures subjected to thermal loading
ML Dunn et al.
JOURNAL OF MICROELECTROMECHANICAL SYSTEMS (2002)
Effects of viscous flow on residual stresses in film/substrate systems
CH Hsueh et al.
JOURNAL OF APPLIED PHYSICS (2002)