Heterogeneous deformation recorded by magnetic fabrics in the Pyrenean Axial Zone

Magnetic fabrics studies (AMS) are a useful tool in order to describe the distribution of deformation in orogenic areas where conventional techniques are difficult to apply, especially due to the lack of proper strain markers. In the present study, AMS and structural analysis are used to define the distribution of deformation in the Central Axial and Nogueres Zones, an area of strong structural changes (i) in the geometry of the antiformal stack defining the Pyrenean Axial Zone and (ii) the distribution of Alpine cleavage. The studied rocks are Lower-Middle Triassic red beds that crop out in three different stacked thrust units (Bielsa, Nogueres and Orri). Primary sedimentary fabrics are preserved in the uppermost thrust units (Nogueres Zone), but a high percentage of the sampling sites shows an overprint of Alpine compression on magnetic fabrics, with the magnetic lineation mostly parallel to the tectonic grain defined by compressional structures and the magnetic foliation showing different orientations between the poles to cleavage and bedding. The development of compressional fabrics strongly depends on the structural position of the sites, and two deformation gradients can be inferred: the southern margin of the Axial Zone (Orri and Bielsa units) shows strong internal deformation, increasing towards the North; farther north (in the restored cross-section), deformation is in general terms lower, but increases towards the basal thrust of the Nogueres Zone. The heterogeneous distribution of Alpine internal deformation indicates a preferred development of cleavage in the Variscan basement and overlying units of the southern margin of the Axial Zone (mainly in the Orri unit), that could be partly controlled by the tectonic load resulting from the stacking of thrust sheets. (C) 2013 Elsevier Ltd. All rights reserved.