Related references
Note: Only part of the references are listed.Adhesion strength in laminated glazings containing multilayer solar control coatings
J. O. Aguilar et al.
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2012)
ELASTIC FOUNDATION ANALYSIS OF UNIFORMLY LOADED FUNCTIONALLY GRADED VISCOELASTIC SANDWICH PLATES
A. M. Zenkour et al.
JOURNAL OF MECHANICS (2012)
Beam on elastic foundation with anticlastic curvature: Application to analysis of mode I fracture tests
Julien Jumel et al.
ENGINEERING FRACTURE MECHANICS (2011)
Impact of Near-Surface Thermal Stresses on Interfacial Reliability of Through-Silicon Vias for 3-D Interconnects
Suk-Kyu Ryu et al.
IEEE TRANSACTIONS ON DEVICE AND MATERIALS RELIABILITY (2011)
FDM analysis for MHD flow of a non-Newtonian fluid for blood flow in stenosed arteries
D. S. Sankar et al.
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2011)
Air-gaps for high-performance on-chip interconnect part I: Improvement in thermally decomposable template
Seongho Park et al.
JOURNAL OF ELECTRONIC MATERIALS (2008)
Snap transitions in adhesion
Richard M. Springman et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2008)
Sacrificial CVD film etch-back process for air-gap Cu interconnects
Shoichi Uno et al.
THIN SOLID FILMS (2007)
Chemical etching solutions for air gap formation using a sacrificial oxide/polymer approach
F. Gaillard et al.
MICROELECTRONIC ENGINEERING (2006)
Advanced Cu interconnects using air gaps
LG Gosset et al.
MICROELECTRONIC ENGINEERING (2005)
Process and reliability of air-gap Cu interconnect using 90-nm node technology
J Noguchi et al.
IEEE TRANSACTIONS ON ELECTRON DEVICES (2005)
Reliability challenges for copper interconnects
BZ Li et al.
MICROELECTRONICS RELIABILITY (2004)
Effect of deposition methods on dielectric breakdown strength of PECVD low-k carbon doped silicon dioxide dielectric thin films
H Zhou et al.
MICROELECTRONICS JOURNAL (2004)
Distribution kinetics of polymer thermogravimetric analysis: A model for chain-end and random scission
Y Kodera et al.
ENERGY & FUELS (2002)
Single-chip condenser microphone using porous silicon as sacrificial layer for the air gap
W Kronast et al.
SENSORS AND ACTUATORS A-PHYSICAL (2001)
Share Paper
