Related references
Note: Only part of the references are listed.Pressureless brazing of zirconia to stainless steel with Ag-Cu filler metal and TiH2 powder
G. W. Liu et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2008)
Joining of partially sintered alumina to alumina, titanium, Hastealloy and C-SiC composite using Ag-Cu brazes
R. Asthana et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2008)
Effect of interfacial thickness and residual stress on the mechanical property of the alumina-stainless steel braze joint interface
Abhijit Kar et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
Mechanical behavior and microstructural analysis of alumina-titanium brazed interfaces
M. C. A. Nono et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)
Brazing of hot isostatically pressed-Al2O3 to stainless steel (AISI 304L) by Mo-Mn route using 72Ag-28Cu braze
P Mishra et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2005)
Active brazing of pure alumina to Kovar alloy based on the partial transient liquid phase (PTLP) technique with Ni-Ti interlayer
CG Zhang et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2002)
Effects of residual stress on fracture strength of Si3N4/stainless steel joints with a Cu-interlayer
H Chang et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2002)
Fracture behavior and reliability of brazed alumina joints via Mo-Mn process and active metal brazing
SH Yang et al.
JOURNAL OF MATERIALS RESEARCH (2000)
Share Paper
