Pre-treatment of adsorbents for waste water treatment using adsorption coupled-with electrochemical regeneration

With the aim to address waste water treatment problems, a novel and economic water treatment technology was introduced at the University of Manchester. It comprised of a unique combination of adsorption and electrochemical regeneration in a single unit. This process successfully eliminated a number of organic pollutants by using an electrically conducting adsorbent material called Nyex (TM) which was a modified form of synthetic graphite. To expand the scope of other graphite types in waste water treatment applications, natural vein and recycled vein graphite materials were selected for electrochemical surface treatment (pre-treatment) in order to evaluate their adsorptive and electrical properties. New graphite based adsorbents were developed and characterized using a laser diffraction particle size analyser, BET surface area, SEM analysis, X-ray (EDS) elemental analysis, X-ray powder diffraction, Boehm surface titration, Zeta potential electrical bed conductivity and bulk density measurements. Boehm surface titration and EDS (X-ray) elemental analysis showed a significant increase in oxygen containing surface functional groups. Although, no significant improvement in bed electrical conductivity was found to occur after electrochemical surface treatment, however, natural vein and recycled vein graphite materials presented highest bed electrical conductivity amongst competing graphite materials. Aqueous solution of acid violet 17 as a standard pollutant was used to evaluate the comparative performance of these adsorbents. The investigations revealed that electrochemical surface treatment contributed to an increase in the adsorption capacity by a factor of two only for natural vein graphite. Un-treated recycled vein graphite adsorbent delivered the same adsorptive capacity (3.0 mg g(-1)) to that of electrochemically treated natural vein graphite. The electrochemical regeneration efficiency at around 100% was obtained using a treatment time of 60 and 30 min, current density of 14 mA cm(-2), charge passed of 36 and 18 C g(-1), for synthetic graphite, natural and recycled vein graphite materials respectively. Relatively a small consumption of electrical energy, 24 J g(-1), for regenerating natural vein graphite adsorbent versus 36J g(-1) for synthetic graphite adsorbent, was found to be required for destruction/oxidation of adsorbed acid violet 17. Multiple adsorption/regeneration cycles presented no loss in adsorptive capacity over 5 adsorption/regeneration cycles. The use of natural and recycled vein graphite adsorbents offered some advantages over graphite intercalation based adsorbents with reduced electrical energy consumption during regeneration and simpler separation of particulate adsorbent. (C) 2013 The Korean Society of Industrial and Engineering Chemistry. Published by Elsevier B.V. All rights reserved.